question

[legalize420]

if i get a 200amp alt will i have to modify any power wires, or can i bolt it up and go?

 

[95COBRA241]

I believe you can just bolt it up and go unles of course the wires are cracked or worn.

 

[legalize420]

I believe you can just bolt it up and go unles of course the wires are cracked or worn.

paul, you should go out to moroso this weekend if your not working or busy. im sure there are a few people from here going along with a few people from southfloridastangs.com . im getting my 373s installed wed so im going out fri and sat . sat is 4:30pm-2am

 

[95COBRA241]

I might, but my car is not ready to run...its semi-disassembled while the 347 is being built.

P.S. thanks for the TB, I haven't tried to get the screw out but I'm sure it can be drilled and tapped. My tuner says its not a big deal.

 

[legalize420]

I might, but my car is not ready to run...its semi-disassembled while the 347 is being built.

P.S. thanks for the TB, I haven't tried to get the screw out but I'm sure it can be drilled and tapped. My tuner says its not a big deal.

take to police cruise out there

 

[legalize420]

anyone else?

 

[wytstang]

Yes you do
http://www.jdsperformance.com/index.asp?initemuid=552&fcmd=item&inmake=ford

 

[HISSIN50]

Yep, I Agree with Danny - I would not run the stock cable (looks like about 6 AWG), especially since they are old and suffer IR.

I would use a 2 AWG myself, though 4 AWG might suffice. Be sure to fuse it appropriately for the weakest link (read the cable used, unless you go for the gusto with your new cable).

Danny, am I misreading prices or are they cheap there?

Good luck.

 

[wytstang]

They are cheap there probably the cheapest I have found thus far. I picked up my 255lph there and even with Fl taxes they beat others by $10+ shipped.

 

[legalize420]

thanks guys