Hi,
I'm currently rerouting all my harnesses in my fox. I went to run the drivers side harness(runs along the drivers side panel and up to the front headlights) through the drivers side fender opening but realized that the headlight connects/sockets will not fit through the factory hole that is just behind the drivers side strut tower.
I would like to know what Masonozz and others have done to get around this. Did you just use a whole saw? Did you cut a new whole? I'd appreciate any photos/information that you can give me. Thanks!
I'm currently rerouting all my harnesses in my fox. I went to run the drivers side harness(runs along the drivers side panel and up to the front headlights) through the drivers side fender opening but realized that the headlight connects/sockets will not fit through the factory hole that is just behind the drivers side strut tower.
I would like to know what Masonozz and others have done to get around this. Did you just use a whole saw? Did you cut a new whole? I'd appreciate any photos/information that you can give me. Thanks!