• Mustang Forums
  • Mustang Sound & Shine All

Radio wire color problem on 95 mustang conv.

  • Thread starter Thread starter bobgaffney1249
  • Start date Start date Jul 5, 2008
B

bobgaffney1249

New Member
Jul 5, 2008
1
0
0
Jul 5, 2008
#1
  • Jul 5, 2008
  • #1
Problem finding the correct color wires on my 95 mustang convertible to install new pioneer radio, CAN ANYONE HELP?

I pulled up on the internet wire diagram for the car, but I can't find any of the colors that every diagram appears to be talking about.

I also pulled the rear left side speaker panel to make sure what colors they were and sure enough it's the colors on the diagram.
What am I doing wrong?

I powered the radio, everything works fine, but cannot find the correct wires to connect to the radio.
HELP!!!!!
 

2BADSTANGS

Member
Jun 19, 2008
385
1
18
Colorado
Jul 6, 2008
#2
  • Jul 6, 2008
  • #2
You probably have an amplified system. Meaning that the wires connected to the radio are not connected directly to your speakers, but rather to the amplifier. The wire colors you have should be found coming out of the amp. If you have pods on your doors that say "Mach 460", you definately have an amplified system.
 
4

4Pnt6GT

New Member
Jul 16, 2008
1
0
0
Jul 16, 2008
#3
  • Jul 16, 2008
  • #3
I agree wit 2BADSTANGS...I used to install car stereos and I did a few mustangs. More than liely it is amplified. If I"m not mistaken you probably have 2 sets of wires plugging into the stereo. If not it will only be one. (Forgive me if I'm wrong, I'm in Iraq and doing this from memory) I had a 98 GT that I put an aftermarket stereo in (PIMA). If it is amplified, meaning you have the MACH System, the amp SHOULD BE on the floor UNDER where the radio is. Meaning you will have to pull out the bottom section (where your shifter is) and look for it. It's a little inconspicuous, but I'm sure you will see it. All of your wires should be there. Try getting in touch with Crutchfield (Crutchfield.com) Normally they can point you in the right direction with little or no hassle. I hope this helps.

Bryan
 
You must log in or register to reply here.

Similar threads

C
Electrical HELP! 1989 5.0 Stick, Voltage Bleed onto Ignition Trigger wire
  • ChickenDeluxe
  • May 14, 2026
  • Fox 5.0 Mustang Tech
Replies
7
Views
225
Fox 5.0 Mustang Tech May 24, 2026
ChickenDeluxe
C
S
Rally-Pac Wiring
  • Sparksteam
  • Oct 14, 2025
  • 1965 - 1973 Classic Mustangs -General/Talk-
Replies
2
Views
221
1965 - 1973 Classic Mustangs -General/Talk- Oct 15, 2025
Sparksteam
S
C
Electrical Under dash wiring
  • ChicagoMustang
  • Apr 17, 2026
  • Fox 5.0 Mustang Tech
Replies
1
Views
113
Fox 5.0 Mustang Tech Apr 17, 2026
AeroCoupe
G
New, 2005 Red V6 Convertible
  • Ginger2005
  • Jan 3, 2026
  • The Welcome Wagon
Replies
3
Views
378
The Welcome Wagon Jan 4, 2026
2Blue2
L
2000 Mustang PATS - Broken Key and Wire - HELP!
  • Laree Taylor
  • May 7, 2026
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
10
Views
196
1996 - 2004 SN95 Mustang -General/Talk- May 12, 2026
manicmechanic007
Share:
Bluesky Email Share Link
  • Mustang Forums
  • Mustang Sound & Shine All
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?