Thank you I was thinking that too. I have the 6 long ones for thatThe upper to lower bolts won't work. You'll need explorer specific bolts for that.
But you can use your stock lower to block bolts.
Can I use my stock HO bolts for use with the explorers intake lower?
Correct. but he showed pics of the upper bolts as well, so wasn't sure if he was including those in his question as well
I'm picking up these. So a spacer will add hp too?All good my friend. Good advice all around. I would add he might consider a small spacer , as it will aid in both HP and VC clearance. A 1/2 inch spacer should clear a stock hood. Obviously it will require longer upper bolts.
I'm picking up these. So a spacer will add hp too?
I doubt these the bolts with that kit will work but I'm guessing it does
These valve covers look like for efi right? And how would I install a filler neck to it? Thanks guys
Also I haven't put a bolt in it. But without. The intake barely clears the hood it seems. So now I need a cowl hood
Sent from my SPH-L720 using Tapatalk 4
I had a gasket for it I thought but it was way small. Didn't even fit the bolt pattern for the studs on either intake. It previously had rtvThee are gaskets for the EGR...you don't need to run rtv there if you want
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?