Rear End Setup Help Needed!!!!!!!

iaff284

New Member
Feb 29, 2004
29
0
1
Champaign, IL
As the title states I need serious help with my rear gear setup. I am putting 3.73 used gears in an 8.8 with all new bearings and seals with a rebuilt trac-loc. I measured both setups and my new pinion bearing was taller than the origional, of which had been disassembled prior to me getting it, so I needed a thinner pinion shim. I measured twice pressed once and came up with a wear pattern on the upper quarter of the heel of the coast side and the lower quarter of the toe of the drive side. Which by several different sources found online indicates I need a thinner pinion shim. I have since made three shim changes and the pattern persists. I started with a .022 shim and I am currently at a .012 with little change in the pattern. Help someone please help as I have to rap this up tomorrow. I tried to take pics but couldn't get a decent focus.
 
I am in the same boat except my wear pattern seems to be different than yours but still seems different than ideal. My first question is how is your new bearing thicker? Did you measure it with the bearing set firmly down in the race? How did you measure? They should be the same, all of my bearings came out exactly same as factory. I used ford gears and set it up with the new parts just like it was with the old parts. It still apparently did not turn out just quite right. But I am just like you, a shim change on the pinion does not seem to have much affect. Also, everytime I change the pinion depth, I have to change the shims around on the carrier and it still doesnt come out right. For yours though, makes sure your backlash is between .008-.015 and that your carrier shims are as thick as factory. Other than that, I dont know cuz I am in the same position. Hope we find out something. :shrug:
 
did you measure the entire pinion? that might be the problem. is there a number painted on the pinion shaft still? probably not if its used. the difference comes in at the actual pinion gear not at the entire length.
 
I measured the races individually and they were the same. I put both bearing in a vice and snug them enough to hold them and then measured in three places. There are no numbers left. My backlash has been everywhere from .008 to .020 with little effect. I measured the pinion head height on both and it was the same. Any other ideas would be helpful
 
So far I have set up several 7.5 in and one 8.8 with good results with very basic effort. I did, however, build a case spreader in the early 90's to make it easier to do.

I also found that I had to move things more than I expected in a couple cases, as you noted. I have had very good results with Reider Racing's differential shimming setups, with the stackable shims.

Try to get it as good as you can, then put it in and run it, and see if it works. If it is not noisy, its probably ok.

I did the pinion bearing thing about 5 times on my last setup, with all new gears. Can't remember the numbers, but I believe I moved it at least .010 in.

I set up one 7.5 back in 92 or so, and then reduced the backlash twice in 03 and 04, and it stll works fine. This is the one that's survived my trips into the 12's.