I've been gathering parts for my roller block to go into my '65 fastback, I will be using the top loader and original bell housing. I'm looking for ideas on the clutch. I want to make sure, before purchasing, that a 5.0 clutch will fit under the '65 bell.
Being that I don't have the top loader with me at the office..can somebody help witht the spline count on a top loader? I've had great success with Centerforce clutches and will most likely go that route again...as for which one??? I had the Centerforce (one) in my stock '88 (had 3.55's in the rear) and it worked very well.
Don't forsee this engine build going beyond 300 HP...thoughts so far are using an F303 cam, forged flat-tops, 1.6 roller rockers and the 289 heads...carb--who knows. I've got a 1.12 venturi four bbl, not sure if it will be enough though.
thanks fella's!
Jim
Being that I don't have the top loader with me at the office..can somebody help witht the spline count on a top loader? I've had great success with Centerforce clutches and will most likely go that route again...as for which one??? I had the Centerforce (one) in my stock '88 (had 3.55's in the rear) and it worked very well.
Don't forsee this engine build going beyond 300 HP...thoughts so far are using an F303 cam, forged flat-tops, 1.6 roller rockers and the 289 heads...carb--who knows. I've got a 1.12 venturi four bbl, not sure if it will be enough though.
thanks fella's!
Jim