• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

Runnig Rich when warm

  • Thread starter Thread starter 93 LX
  • Start date Start date Jan 12, 2008

93 LX

Founding Member
Jun 2, 2000
3,081
3
0
Norwalk, CA.
Jan 12, 2008
#1
  • Jan 12, 2008
  • #1
86 5.0L HO SD car.

I get no codes when this is going on. I was wondering if a slow reacting or bad functioning ACT sensor would cause this?
 
M

Mike85000

New Member
Feb 22, 2007
65
0
0
Jan 12, 2008
#2
  • Jan 12, 2008
  • #2
I'd suspect the ECT or O2 sensors. Sounds like when it gets into closed loop (warmed up) that's when it goes rich. I'm sure you can test the ACT to see if it is range, if you go to fordfuelinjection.com i think he has some charts comparing ambient temp to resistance.

There are guys on here that know a lot more than I do however, i'm sure they'll chime in.
 

93 LX

Founding Member
Jun 2, 2000
3,081
3
0
Norwalk, CA.
Jan 12, 2008
#3
  • Jan 12, 2008
  • #3
O2 Sensors are new, ECT is new as well. Argh!@
 

jrichker

StangNet's favorite TOOL
In Remembrance. Thank you for your contributions
Mar 10, 2000
27,512
2,813
234
Dublin GA
Jan 12, 2008
#4
  • Jan 12, 2008
  • #4
Dumping the codes will normally show a faulty sensor. The ACT & ECT may be on the outer limits and not set a code but cause problems. Use a DVM or multimeter to check them.

Pin 25 ACT signal in. at 50 degrees F it should be 3.5 volts. It is a good number if the ACT is mounted in the inlet airbox. If it is mounted in the lower intake manifold, the voltage readings will be lower because of the heat transfer.

Pin 7 ECT signal in. at 176 degrees F it should be .80 volts

The ACT & ECT have the same thermistor, so the table values are the same.

Here's the table: The values are +/- 15%, so don't get worried if your readings vary a little bit.

Voltages are measured across the two connector pins of the sensor with the sensor connected. Some safety pins used to probe the connector from the rear will be helpful

50 degrees F = 3.52 v
68 degrees F = 3.02 v
86 degrees F = 2.62 v
104 degrees F = 2.16 v
122 degrees F = 1.72 v
140 degrees F = 1.35 v
158 degrees F = 1.04 v
176 degrees F = .80 v
194 degrees F = .61
212 degrees F = .47 v
230 degrees F = .36 v
248 degrees F = .28 v

Ohms measures at the computer with the computer disconnected, or at the sensor with the sensor disconnected.
50 degrees F = 58.75 K ohms
68 degrees F = 37.30 K ohms
86 degrees F = 27.27 K ohms
104 degrees F = 16.15 K ohms
122 degrees F = 10.97 K ohms
140 degrees F = 7.60 K ohms
158 degrees F = 5.37 K ohms
176 degrees F = 3.84 K ohms
194 degrees F = 2.80 K ohms
212 degrees F = 2.07 K ohms
230 degrees F = 1.55 K ohms
248 degrees F = 1.18 k ohms
 

93 LX

Founding Member
Jun 2, 2000
3,081
3
0
Norwalk, CA.
Jan 12, 2008
#5
  • Jan 12, 2008
  • #5
I think i found the issue. I pulled the ACT connector and it was very diry. Cleaned it and it seems to be running much better.
 
8

86bluecobra

Advanced Member
Dec 20, 2004
4,265
12
69
B.C. Canada
Jan 15, 2008
#6
  • Jan 15, 2008
  • #6
93 LX said:
O2 Sensors are new, ECT is new as well. Argh!@
Click to expand...
I know you found the problem but do not be fooled into thinking just because a sensor is new it is functioning properly. I had a new ECT sensor in my f-150. It was 1 year old and it crapped out on me. Sometimes they fial on you and you would not suspect them.
 

93 LX

Founding Member
Jun 2, 2000
3,081
3
0
Norwalk, CA.
Jan 16, 2008
#7
  • Jan 16, 2008
  • #7
I would think if the sensor failed it would throw a code or 2. This was more or less the wrong readings but they were not out of range to throw a code.
 
You must log in or register to reply here.

Similar threads

J
Engine Tuning...?
  • justadude07
  • May 30, 2026
  • Fox 5.0 Mustang Tech
Replies
8
Views
397
Fox 5.0 Mustang Tech Aug 21, 2026
Qtrhrse23
S
Fuel ‘88 GT Runs Rich Cold — Fixes Itself When I Unplug Sensors (ECT, MAF, O2, etc.)
  • Sufarry
  • Nov 6, 2025
  • Fox 5.0 Mustang Tech
Replies
12
Views
1K
Fox 5.0 Mustang Tech Nov 9, 2025
Mustang5L5
M
Engine Unexplainable Exhaust Pop and Gurgle
  • Mrnissen122
  • Feb 14, 2026
  • Fox 5.0 Mustang Tech
Replies
12
Views
850
Fox 5.0 Mustang Tech Feb 18, 2026
Noobz347
S
Idles great, but stumbles when driving
  • Stang9050
  • Oct 15, 2025
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 2
Replies
27
Views
924
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Nov 8, 2025
Mcmahst
H
97 cobra maf sensor help
  • Hopper1979
  • Oct 16, 2026
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
4
Views
162
1996 - 2004 SN95 Mustang -General/Talk- Oct 17, 2026
CAMTWO1070
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?