i have a 67 fastback ,i stripped it down its up on jacks, the suspention is the only thing left to take off and ready to start replacing things the frame rails up front , floor pans , driverside rocker, trunk floor and part of the rear frame off the trunk are pretty rusted.. my question is
how do i tackle this can of worms
1 where do i start - front, middle, or back ( rockers , rails, or pans )
2 how do i support everything when one piece is off so it wont move or twist
3 is there a site or does anyone have frame diagrams with dimentions to make sure that things are square and in the right place
i posted a while back that its a father and sons project, we were making a room in my polebarn to do this, so we are ready to start it.
any info or tips would be greatly apriciated - thank you
how do i tackle this can of worms
1 where do i start - front, middle, or back ( rockers , rails, or pans )
2 how do i support everything when one piece is off so it wont move or twist
3 is there a site or does anyone have frame diagrams with dimentions to make sure that things are square and in the right place
i posted a while back that its a father and sons project, we were making a room in my polebarn to do this, so we are ready to start it.
any info or tips would be greatly apriciated - thank you