• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

same problem....driving me crazy

  • Thread starter Thread starter 90mustangfan
  • Start date Start date Oct 31, 2005

90mustangfan

New Member
Oct 18, 2005
93
0
0
So cal
Oct 31, 2005
#1
  • Oct 31, 2005
  • #1
I get codes 41 and 91 in CM and KOER tests. I have checked for vaccum leaks many times, Im almost positive its not a vaccum leak...The car stumbles alittle when I first start it. It will stubmle from idle to 1000rpm. Then after driving for about 10 min the CEL comes on and it doesnt stumble, and the car seems to loose power...I can tell you its not the following items cause I replaced them: the EGR valve, vaccum lines, O2 sensor, new wires, plugs,cap...I have cleaned the following parts: Maf, set tps, set timming 10*, cleaned IAC....the car idle OK...it kinda bounces from 800-700rpm...surging idle slightly...cant tell if its cause of the cam or not....One thing that concerns me is the fuel pump...when the CEL comes on at that same time you can hear the fuel pump start to whine slightly...but it wines sometimes with the CEL off. Here are some other problems If they affect the car running lean...there is 2 holes, 1 in each cat where the smog tube goes, that tube isnt there so there is an exhaust leak. I doubt that will cause it to run lean becuase the holes are after the O2 sensor,so I doubt fresh air is going to travel upstream against the flow, and cause the sensor to read lean or something...I also checked to see if the O2 sensor are even getting power...they are, it seem that the new o2 sensors are working properly...If somone can help be before I go crazy and sell it cause Ive been chasing these codes for aobut 3 months...Ive went through the car and checked it for loose connection, bad hoses etc...I have found nothing....
 

DTT92LX

New Member
Oct 28, 2003
185
1
0
Downingtown, PA
Oct 31, 2005
#2
  • Oct 31, 2005
  • #2
I'd say you can't rule out the vac leak or o2 sensors until those codes don't appear any more... The computer is throwing them for a reason.
Have you tested the o2s? If not, you'd better. They are pretty sensitive pieces of equipment. Maybe you got a bum batch. It's been known to happen! Also there are plenty of places for a vac leak to happen. Sure you checked them all?
 

90mustangfan

New Member
Oct 18, 2005
93
0
0
So cal
Oct 31, 2005
#3
  • Oct 31, 2005
  • #3
what are the chances of getting 2 bad O2 sensors...Im going to recheck for vaccum leaks...will vaccum leak cause me to get those codes or will the fuel pump whinning cause it to run lean...well a fuel pump going bad,mabye its not supporting enough fuel for the engine causing it to run lean...could this be...any ideas...im going to try and run some seafoam and check for leaks..
 

DTT92LX

New Member
Oct 28, 2003
185
1
0
Downingtown, PA
Oct 31, 2005
#4
  • Oct 31, 2005
  • #4
Now you're thinking along the right lines. Chances are slim on the o2s. But they're there. Chances are better that its vac related and that's where you're starting to look. The fuel pump may be an issue but it's not consistent. The 'puter codes are consistent so I say resolve them first and go from there.
 
B

bsedwebt70-5.0

New Member
Jul 1, 2004
320
0
0
Charlottesville, VA
Oct 31, 2005
#5
  • Oct 31, 2005
  • #5
I bumped my fuel pressure 5lbs up and cured my 41/91 KOER headache and it made the car run cooler too! This was done after doing EVERYTHING to find out what was going on - Vacuum, O2's, ALL sensors, Fuel filter, Fuel pump, etc.... I hear what you are saying about the fuel pump noise - CHECK IT OUT! Put a guage on it and see what it is doing - mine went bad and pressure was dropping way low at times - it will cause a host of problems. Check the fuel filter (cheap) Check the fuel sock inside the tank (mine had goo on it slowing the flow one time) etc... I chased 41/91 for weeks and worked on it for hours and hours -- good luck
 

Zero_chance

Founding Member
May 29, 2001
1,244
7
59
Maricopa, AZ
Nov 1, 2005
#6
  • Nov 1, 2005
  • #6
A good way to check for vac leaks is to spray brake kleen on suspect areas and if there is a leak youll hear the difference in the engine when it gets sucked in.
 
You must log in or register to reply here.

Similar threads

Engine Random Misfire at idle.
  • Gulftown980x
  • Jul 29, 2026
  • SN95 4.6L Mustang Tech
Replies
11
Views
613
SN95 4.6L Mustang Tech Jul 31, 2026
squeak93
S
Idles great, but stumbles when driving
  • Stang9050
  • Oct 15, 2025
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 2
Replies
27
Views
907
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Nov 8, 2025
Mcmahst
M
Help! 2003 GT misfire when hot
  • Modular03
  • Feb 10, 2026
  • SN95 4.6L Mustang Tech
Replies
4
Views
618
SN95 4.6L Mustang Tech Feb 13, 2026
Mustang5L5
S
Fuel ‘88 GT Runs Rich Cold — Fixes Itself When I Unplug Sensors (ECT, MAF, O2, etc.)
  • Sufarry
  • Nov 6, 2025
  • Fox 5.0 Mustang Tech
Replies
12
Views
1K
Fox 5.0 Mustang Tech Nov 9, 2025
Mustang5L5
D
Running both lean and rich with O2 heat codes
  • Danceswithfire5
  • Aug 30, 2026
  • SN95 V6 Mustang Tech
Replies
1
Views
181
SN95 V6 Mustang Tech Sep 5, 2026
apple99Mustangdude
A
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?