i have an sct 4 bank chip on an a9l ecu. LOONG story short, it is not fitting "tight" to the ecu board. when i hit hard bumps, or shut my passenger door, it causes a major disruption to the car. some of you saw my in-car video a few weeks ago. that was results of the chip being loose. we made the issue "better" by packing cardboard around it, then closing the ecu case around it. this worked great for a week or so, now it's shown its ugly head again.
short of a new expensive chip; is there anything you guys know of, that could perhaps slip inside the chip or similar to make this fit tighter? we looked at the fingers on the chip and my friend said he couldnt bend them to increase the tension.
even a good material i could use that will not allow as much movement as cardboard, but will still be form fitting..
short of a new expensive chip; is there anything you guys know of, that could perhaps slip inside the chip or similar to make this fit tighter? we looked at the fingers on the chip and my friend said he couldnt bend them to increase the tension.
even a good material i could use that will not allow as much movement as cardboard, but will still be form fitting..