Serpentine Belt Re-route

Can buy reverse rotation pump but I believe will need to change timing cover as well. Look at early 80's full size Ford pumps and TC. Will also need a new radiator fan otherwise it will blow in the wrong direction if you reverse the rotation.

We have a similar set up to yours in a 94 Mustang but did not change the pump. Instead I made a bracket from aluminum plate about 3/8" thick and mounted an idler pulley above the water pump, to the right of it.

Belt comes off the crank shaft in clockwise direction, goes around the same water pump you have today (spins it counter clock wise), then under the alternator, comes off the top side of the alternator, goes under yout tensioner idler, then over the top of the new idler you will add then straight down to the crank shaft. The pupose of the new idler is to allow you to bring the belt down past the reverse rotating water pump without interfering with it.

Is the picture you are showing the car it is in now? I ask because I see power steering lines. You can buy the pulleys for the ac delete (basically a pulley that just spins and takes the place of where the ac compressor was) and they also have for smog pump delete and you could run the belt that way.