Shelby drop template

[Ferf]

Can someone point me to the Shelby drop template?

Thanks,

Chris

 

[Ferf]

Actually, I am finding variations of the template. Can someone hook me up with the "correct" template?

Later,

Chris

 

[krash kendall]

This one prints off the correct size.

http://members.cox.net/mbstang/template.jpg

 

[Opentracker]

With the 1" Shelby drop, the deal is to make sure the new holes are the right distance apart or the arms won't fit. The 65-66 cars are 3-3/4" apart, the 67-up cars are 4-3/4" apart. I start with a punch, then go to a 1/8" drill bit. Three more steps of drill bits to 1/2" measuring each time. I finish with a 1/2" bit and dress it to 17/32 with round file.

I have paper templates that are the right size for both 65-66 cars and 67-up cars. They are free, including shipping in all 50 states by sending an email to [email protected] -

John

 

[Hack]

I just used a 1/2" bit to drill the new holes. The bolts were a tight fit, but I prefer that to looser. 1/2" drill is also cheaper and easier to find.

 

[RGS0907]

This one prints off the correct size.

http://members.cox.net/mbstang/template.jpg

I'd measure it and maybe compare it to the templates found in catelogues, like Branda. Some printers will alter the size of a print-out a little. I wouldn't trust that it's correct without checking.

 

[Opentracker]

It printed 1/16" off with our printer. It is a good template if the holes are made 3 3/4" apart for the early cars and 4 3/4" apart for the 67-up cars. Even with my metal template that I have been using for years, I always check the measurement. Measure twice - drill once.

John

 

[krash kendall]

Mine printed within 1/32", which means you would have to drill both holes within 1/64" to get better tolerance.