• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

SHOCKING sensation

  • Thread starter Thread starter XBLCanterX
  • Start date Start date May 29, 2005
X

XBLCanterX

New Member
Dec 28, 2003
34
0
0
Lexington
May 29, 2005
#1
  • May 29, 2005
  • #1
before you guys start calling me a retard...

is it normal for a distributor cap to shock you when there is NO bare wires showing, everything is hooked up right, and firing order correct?????

cause mine shocked the bejusus outta me just a minute ago...twice

i dont understand why it shocked me though...i thought it had to be a bare wire or terminal.

could it be a bad ground somewhere???

help please...i cant take much more shock therapy.
 

90mustangGT

I felt sorry for girls because
Founding Member
Jan 15, 2002
2,773
17
89
Dallas, GA
May 29, 2005
#2
  • May 29, 2005
  • #2
Bad insulation on the wires or a cracked cap or a carbon track will cause this.
 

Stang8URMPRT

Active Member
Dec 28, 2003
1,100
1
38
Daytona Beach, FL
May 29, 2005
#3
  • May 29, 2005
  • #3
Uhhh... If you h ave the coil wire hooked up in the middle and no other wires on the cap... and crankign the car, those open teminals will give ya a shock you'll never forget.
 
S

Scorcher2005

Member
Apr 17, 2004
883
0
16
South Carolina
May 29, 2005
#4
  • May 29, 2005
  • #4
lol, if it shocked you once, y did you let it do it again?
 
X

XBLCanterX

New Member
Dec 28, 2003
34
0
0
Lexington
May 29, 2005
#5
  • May 29, 2005
  • #5
i have brand new FRPP 9mm wires and a brand new MSD cap and rotor...and like I said everything is right...but god **** it hurt :damnit:

wasnt sure what happened the first time lol
 

cjman15

Banned
Apr 15, 2004
1,009
0
0
Fairfield, PA
May 29, 2005
#6
  • May 29, 2005
  • #6
Ya-ouch
 

HISSIN50

"How long does it take to get help in here?
15 Year Member
Nov 29, 1999
31,179
34
129
May 29, 2005
#7
  • May 29, 2005
  • #7
it is easier for it to happen if you have your other hand (for instance) touching metal (like the radiator support, plenum, etc) as this allows an easier path to ground than through your shoes.

I get it all the time (i get static electricity shocks all the time too. dry air in the desert).
 
X

XBLCanterX

New Member
Dec 28, 2003
34
0
0
Lexington
May 29, 2005
#8
  • May 29, 2005
  • #8
i can stand beside the car not touching anything....and put one finger on any boot on the cap and ZAAPPP! presto, fried finger... WTF?!
 

sgarlic

Founding Member
Apr 21, 2001
3,085
1
56
May 30, 2005
#9
  • May 30, 2005
  • #9
XBLCanterX said:
wasnt sure what happened the first time lol
Click to expand...

Reminds me of a time last year when my buddy and I were doing some ops checks in the cockpit of an F-16. My buddy, apparently out of curiosity, pulled a little triangular shaped handle on the left side of the console, which was followed by an abrupt "woosh" sound, and then the sound of liquid spilling. Turned out the F-16 was spilling hydraulic fluid EVERYWHERE.. coming from right between the 2 rear landing gear.

My buddy and I promperly cleaned up the mess, then a few minutes later, he said "I'm not sure what happened there.. I want to see if pulling the handle is for sure what caused that." .. and pulled it again, again spilling a ****load more hydraulic fluid everywhere.

Turns out it was the manual release lever for the landing gear. The old "wasn't sure what happened" .. gotta love it.
 
S

Sicarius428

Active Member
Jan 6, 2004
2,085
5
49
May 30, 2005
#10
  • May 30, 2005
  • #10
Ya did that on my 70 (full msd setup) with a tad wet hand... duh... grabbed the strut brace for some support and was adjusting the timing with the other hand... It didn't hurt but I couldn't let go for a second and my arm was a tad numb for a while afterwards.... remember its the amps not necessairly the volts that will kill ya.
Kevin
 
J

jerry beach

Founding Member
May 20, 2002
2,671
0
46
Ocala,FL
May 30, 2005
#11
  • May 30, 2005
  • #11
Thats how I check for spark on a no start. Isnt that what everyone does.
 

ninjacoupe

New Member
Jul 6, 2003
174
0
0
NY
May 30, 2005
#12
  • May 30, 2005
  • #12
I did that once about 15 years ago. Better story would be a bout 20 years ago I pulled the plugwire off of a running dirtbike.
 
You must log in or register to reply here.

Similar threads

Alternator not charging
  • SchwarzStock
  • Jul 6, 2026
  • 1965 - 1973 Classic Mustangs -General/Talk-
Replies
2
Views
98
1965 - 1973 Classic Mustangs -General/Talk- Jul 19, 2026
SchwarzStock
Resolved 93 Mustang 5.0 - Cranks but does not start
  • dan50
  • Jul 18, 2026
  • Fox 5.0 Mustang Tech
Replies
6
Views
168
Fox 5.0 Mustang Tech Jul 18, 2026
dan50
F
Electrical From scratch: alternator wiring
  • fox racer v2
  • Jun 23, 2025
  • Fox 5.0 Mustang Tech
Replies
0
Views
584
Fox 5.0 Mustang Tech Jun 23, 2025
fox racer v2
F
H
Ongoing Battle With Hydraulic Lifters
  • hailer06
  • Jun 8, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
7
Views
316
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jun 9, 2026
Noobz347
1999 Mustang GT - No Start- Need help understanding the fuel pump circuit and how it works
  • 99gtGuy
  • Nov 4, 2025
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
1
Views
536
1996 - 2004 SN95 Mustang -General/Talk- Nov 7, 2025
04newedge-
0
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?