• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

SIMPLE AOD questions...

  • Thread starter Thread starter TheDog
  • Start date Start date Dec 30, 2005

TheDog

Founding Member
Jun 4, 2000
737
0
0
Mobile, AL
Dec 30, 2005
#1
  • Dec 30, 2005
  • #1
I know the stock overdrive gear of an AOD is very sensitive. Therefore usually around town I keep in it D rather than OD. Yes the engine engine revs a little higher but I do it for the sake of the tranny. Am I a doofus for doing this? I know I may be losing a tiny bit of gas mileage for doing this but I don't mind. I just don't want the tranny upshifting and downshifting constantly in traffic around 40-45mph. So to avoid that I just put it in D.
Also when I'm coming to a complete stop at a stop light or something where I have to sit for a minute or a two I put in neutral. I'll throw it in neutral before I come to a stop. About midway through braking I'll throw it into N to ease the strain on the brakes and drive system. Do you think I'm helping any? I feel that I'm saving some gas by having it idle in neutral at a stop light.
So overall, do you think these gear changes are helping me? Or do you think they're running down my AOD tranny prematurely? Either that or the opposite? Thanks!
 

bill302

Active Member
Nov 2, 2005
2,131
1
46
alabama,gadsden
Dec 30, 2005
#2
  • Dec 30, 2005
  • #2
i think you working yourself and the tranny harder by doing this than to just running in o.d. but on the bright side when all your gears wear out you will still have a new o.d. in the tranny.LOL. work the gear or work the pump or work the brakes they all probably even out is it cheaper to replace brakes or tranny parts.
 

timewarped1972

Member
Jun 17, 2004
642
0
16
mesa, az
Dec 30, 2005
#3
  • Dec 30, 2005
  • #3
having 3.73's is right there on the edge of do i put it in o.d or do i leave it in 3rd........same deal here.....but here's what i do...
if i'm cruising for any real distance at 45 or so, i put the tranny in D. i let it shift through the gears, then when i get to about 40 or so, i completely take my foot off the gas, push the shifter into od, and allow it to very gently go to od, then when i come to a stop, i put it back in D and do the same thing over again. that way, it's a very light load gentle enguagement into od. thats one of the reasons i decided to go with a t-5 swap eventually, i figure by the time i do all that manual shifting i might as well have a damn stick...anyway thats how i do it, as long as your not shifting hard into it it should help preserve that od band...i wouldn't worry about putting it in neutral and all that, that shouldn't be any extra strain leaving it in gear while stopped
 

TheBocSez

New Member
Feb 3, 2004
652
0
0
Converse, TX
Dec 30, 2005
#4
  • Dec 30, 2005
  • #4
I think youre wasting you time with the neutral thing but leaving it in drive is a good idea. I have a Lentech street term. VB and it recommeds only using OD when at highway speeds for extended periods. I have 4.10's and usually just drive it with the OD off. Like Timewarp, when I do engage OD, I let my foot off the gas, let OD engage then apply the gas again.
 

The Shape

Founding Member
Jan 11, 2002
2,224
8
49
East ARKANSAS Delta
Dec 30, 2005
#5
  • Dec 30, 2005
  • #5
TheBocSez said:
I think youre wasting you time with the neutral thing but leaving it in drive is a good idea. I have a Lentech street term. VB and it recommeds only using OD when at highway speeds for extended periods. I have 4.10's and usually just drive it with the OD off. Like Timewarp, when I do engage OD, I let my foot off the gas, let OD engage then apply the gas again.
Click to expand...


I agree I don't know that putting it in neutral at stop lights is helping, but I never use OD in town I always leave it in D . Overdrie is just a highway cruising gear. Driving around town it shifts in and out of OD constantly and wears it out faster. And with stock gears hiting OD at 40 mph drops the rpm's so low you loose alot of power. I only use OD if I am going to be cruising above 55 for a long period of time. As for as shifting into OD I have always just held the pedal steady at 55 and shifted it to OD. I may try letting off the throttle first though and see if that is smoother, like you guys suggest.
 

srothfuss

Last night I stabbed the same guy 7 times in a row
Oct 17, 2004
1,796
3
0
Woodward Ave.
Dec 30, 2005
#6
  • Dec 30, 2005
  • #6
Using neutral allows the motor RPM to drop lower than leaving it in a given forward gear. The best way to determine any benift would be to test both methods on the same routes for 2 months straight (each method)
 

7-UP BILL

Founding Member
Jan 4, 2001
885
19
49
My other car is a Firetruck
Dec 31, 2005
#7
  • Dec 31, 2005
  • #7
srothfuss said:
Using neutral allows the motor RPM to drop lower than leaving it in a given forward gear. The best way to determine any benift would be to test both methods on the same routes for 2 months straight (each method)
Click to expand...


It's just the other way around. Car should idle in neutral (park) at around 900 rpm. In gear @ 650.
 

TheDog

Founding Member
Jun 4, 2000
737
0
0
Mobile, AL
Jan 2, 2006
#8
  • Jan 2, 2006
  • #8
aight cool. I'm going to do what i suspected and leave in in D until i go 50+ mph then I'm going to manually put it in OD with my foot totally off the gas then apply gradual pressure to go higher. I really feel this may lengthen the life of my AOD. And as far as a lentech AOD... I'd just love to have a lentech VB.
 

The Shape

Founding Member
Jan 11, 2002
2,224
8
49
East ARKANSAS Delta
Jan 2, 2006
#9
  • Jan 2, 2006
  • #9
I posted a similar thread about shifting into OD on another forum. Here's the link if you wanna check that thread out as well. http://www.corral.net/forums/showthread.php?p=5515972#post5515972
 
You must log in or register to reply here.

Similar threads

Surging/stalling! problem or tune?
  • djj62478
  • Oct 4, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
11
Views
401
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Oct 14, 2026
KRUISR
G
Sputtering/misfiring below 2500rpm
  • Godless
  • Sep 14, 2025
  • 2005 - 2014 S-197 Mustang -General/Talk-
Replies
5
Views
558
2005 - 2014 S-197 Mustang -General/Talk- Sep 14, 2025
gkomo
J
Transmission issues 4r70w
  • Jess!08249
  • Nov 12, 2024
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
1
Views
361
1996 - 2004 SN95 Mustang -General/Talk- Nov 14, 2024
Noobz347
B
Questions About T5 Manual
  • Blackout67
  • Apr 13, 2025
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
10
Views
804
1996 - 2004 SN95 Mustang -General/Talk- Apr 22, 2025
89ripper
P
2002 T5 transmission vibration issue
  • puffoo
  • Feb 22, 2026
  • SN95 V6 Mustang Tech
Replies
0
Views
299
SN95 V6 Mustang Tech Feb 22, 2026
puffoo
P
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?