SN95 Fan Wiring

[Numbles]

Im in the prcess of wiring the elecric fan. I have the relay all setup but when I give it power the fan spins the wrong way. Anyone have a wiring diagram for a an95 electric fan. I have it wired and the ground on the center post and the positive on the bottom post.

Anyone know how to get the fan to spin the right way. I tried reversing the power and ground and it would just spark and heat up the wires without the fan spinning.

Thanks
Dan

 

[Mustang5L5]

My SN95 fan is wired using the outer two posts.

I didn't use the center post but mine is a V6 fan with high speed only. The GT's use the 2nd post for high and low speed.

 

[Grn92LX]

Use this link but substitute the last 3 digits of the relay part # he listed for '156'.

http://www.corral.net/forums/showthread.php?s=&threadid=152293&highlight=sn95+electric+fan

 

[Numbles]

I currently have the relay from painless wiring. 30amp. It says in that thread that the sn95 draws close to 60amps. Is this true. Will I need tp upgrade relays. Or the ralay and the wiring.

 

[Mustang5L5]

60-70 on startup and then around 25-30 continuous.

You want a relay where the continuous draw is around 80% of it's capactiy. So try to get a 40 or 50AMP relay.

I run a Bosch 75AMP on mine

 

[HISSIN50]

I dont agree with that draw figure (it was a continuous draw figure, no?).

EDIT: Mike posted while I ate.