SN95 Seats in a Fox Problem

[onedownfiveup]

I have SN95 Seats out of a 95 GT and I got the passenger seat in with the SN95 brackets just fine without modifications at all. Hooked up the power lumbar and away it went.

Here is the problem. The driver seat is power and power lumbar. There were more than one plug under the seat I figured everything plugged together on the seat and one went from the seat to the bracket and one from the seat to the floor plug in where the old lumbar power was. Well hooked it all up and it's not working at all, the lumbar works but the power seat doesn't move. Anyone had this problem?

 

[stangbear427]

Are you sure the power seat worked before you put it in? I don't have experience with this swap, but using a test light and the almost fullproof "gazinta/gazada" diagnosis, I'd say that's a possibility. (power gazinta here, gazada there, goin in, not coming out, replace part in the middle, all fixed) I'm betting the power seat motor is out of commission?

 

[jadedinpa]

on my power seats (from a 95 as well) i had to hook the harness for the power up, i never even checked if i have power lumbar.

 

[onedownfiveup]

Well it gets 12v. Oh well, I swapped in my 93 brackets so I could go to work tomarrow. I'll figure it out later.