Snow vs MR Freeze vs AIS....Well?

[94GTLaserRC]

I have a very slightly used Snow Stage 2 kit that I havent installed yet. After talking to Wes and reading up on the Alcohol Injection System (AIS) that he has. I may go with that.

Any comments, feedback, etc on the three kits?

RC

The Best Water injection system and water methanol injection systems at AlcoholInjectionSystems.com

 

[turbogt]

bump

 

[94GTLaserRC]

bump

DAMN!!

I got all excited to read your reply and it said "BUMP"

 

[turbogt]

Call me a tease

 

[rodknox]

I bought the AIS Stage 1 fender mount kit without tank and just using my factory windshield washer fluid container. I'm also running a dual nozzle with one nozzle before the Vortech and one after. I picked up 2 psi just doing this. Here's the kit I have.

The Best Water injection system and water methanol injection systems at AlcoholInjectionSystems.com

 

[94GTLaserRC]

I bought the AIS Stage 1 fender mount kit without tank and just using my factory windshield washer fluid container. I'm also running a dual nozzle with one nozzle before the Vortech and one after. I picked up 2 psi just doing this. Here's the kit I have.

The Best Water injection system and water methanol injection systems at AlcoholInjectionSystems.com

I have an almost new Snow Stage 2 kit with packaging I want to sell. I LOVE the AIS and I want the Dual nozzle. Because of my sort of show engine, I dont want the tank in the bay. By washer tank is gone. The Snow requires an upgraded pump for the trunk mount. I love the clean install and dual nozzle of the AIS.

RC

 

[turbogt]

I have an almost new Snow Stage 2 kit with packaging I want to sell. I LOVE the AIS and I want the Dual nozzle. Because of my sort of show engine, I dont want the tank in the bay. By washer tank is gone. The Snow requires an upgraded pump for the trunk mount. I love the clean install and dual nozzle of the AIS.

RC

on another note.. I got my 2.95" pulley on.... I gained about a 1/2 pound of boost is all The pulley wasn't too expensive, but I had to buy a belt too, so that was pretty much a waist... I think if I were in your shoes, I'd just go with the 2.75 and be done with it...

I'm seeing about 10.5# peak now.. It does seem to spool up a little faster, but thats about it...

 

[94GTLaserRC]

on another note.. I got my 2.95" pulley on.... I gained about a 1/2 pound of boost is all The pulley wasn't too expensive, but I had to buy a belt too, so that was pretty much a waist... I think if I were in your shoes, I'd just go with the 2.75 and be done with it...

I'm seeing about 10.5# peak now.. It does seem to spool up a little faster, but thats about it...

I didnt want to go lower because there was a post in the other forum that stated that you are at the upper limits of spinning the Vortech when you go much lower.

I will take the faster spooling tho. I will still be running strong no matter what. If the Vortech goes bad, Ill shell out the extra for the SI upgrade.

Thanks for the info.
RC