Snow vs MR Freeze vs AIS....Well?

94GTLaserRC · Aug 24, 2009

I have a very slightly used Snow Stage 2 kit that I havent installed yet. After talking to Wes and reading up on the Alcohol Injection System (AIS) that he has. I may go with that.

Any comments, feedback, etc on the three kits?

RC

The Best Water injection system and water methanol injection systems at AlcoholInjectionSystems.com

turbogt · Aug 25, 2009

94GTLaserRC · Aug 25, 2009

turbogt said:
bump

DAMN!!

I got all excited to read your reply and it said "BUMP"

turbogt · Aug 27, 2009

Call me a tease

rodknox · Aug 27, 2009

I bought the AIS Stage 1 fender mount kit without tank and just using my factory windshield washer fluid container. I'm also running a dual nozzle with one nozzle before the Vortech and one after. I picked up 2 psi just doing this. Here's the kit I have.

The Best Water injection system and water methanol injection systems at AlcoholInjectionSystems.com

94GTLaserRC · Aug 27, 2009

rodknox said:
I bought the AIS Stage 1 fender mount kit without tank and just using my factory windshield washer fluid container. I'm also running a dual nozzle with one nozzle before the Vortech and one after. I picked up 2 psi just doing this. Here's the kit I have.

The Best Water injection system and water methanol injection systems at AlcoholInjectionSystems.com

I have an almost new Snow Stage 2 kit with packaging I want to sell. I LOVE the AIS and I want the Dual nozzle. Because of my sort of show engine, I dont want the tank in the bay. By washer tank is gone. The Snow requires an upgraded pump for the trunk mount. I love the clean install and dual nozzle of the AIS.

RC

turbogt · Aug 27, 2009

94GTLaserRC said:
I have an almost new Snow Stage 2 kit with packaging I want to sell. I LOVE the AIS and I want the Dual nozzle. Because of my sort of show engine, I dont want the tank in the bay. By washer tank is gone. The Snow requires an upgraded pump for the trunk mount. I love the clean install and dual nozzle of the AIS.

RC

on another note.. I got my 2.95" pulley on.... I gained about a 1/2 pound of boost is all The pulley wasn't too expensive, but I had to buy a belt too, so that was pretty much a waist... I think if I were in your shoes, I'd just go with the 2.75 and be done with it...

I'm seeing about 10.5# peak now.. It does seem to spool up a little faster, but thats about it...

94GTLaserRC · Aug 27, 2009

turbogt said:
on another note.. I got my 2.95" pulley on.... I gained about a 1/2 pound of boost is all The pulley wasn't too expensive, but I had to buy a belt too, so that was pretty much a waist... I think if I were in your shoes, I'd just go with the 2.75 and be done with it...

I'm seeing about 10.5# peak now.. It does seem to spool up a little faster, but thats about it...

I didnt want to go lower because there was a post in the other forum that stated that you are at the upper limits of spinning the Vortech when you go much lower.

I will take the faster spooling tho. I will still be running strong no matter what. If the Vortech goes bad, Ill shell out the extra for the SI upgrade.

Thanks for the info.
RC

Snow vs MR Freeze vs AIS....Well?

94GTLaserRC

Squint as you approach, lest you be blinded by my

turbogt

Member

94GTLaserRC

Squint as you approach, lest you be blinded by my

turbogt

Member

rodknox

New Member

94GTLaserRC

Squint as you approach, lest you be blinded by my

turbogt

Member

94GTLaserRC

Squint as you approach, lest you be blinded by my

Similar threads

Snow vs MR Freeze vs AIS....Well?

Squint as you approach, lest you be blinded by my

Member

Squint as you approach, lest you be blinded by my

Member

New Member

Squint as you approach, lest you be blinded by my

Member

Squint as you approach, lest you be blinded by my

Similar threads

Privacy & Transparency

Privacy & Transparency