So what would it take...

[tag4car]

To get the fronts off the ground just a little bit on my termi?
I am about to bolt on a very ported eaton and most likely jump down to a 2.8x or 2.76 pulley with some supporting idlers. tuning to follow from bamachips

 

[Fastwrx15]

TTT

 

[deftsound]

i think without drag shocks and springs it would be very difficult, power is important of course but if you cant get traction and or your using stock springs your just not going to get it to transfer weight well enough to get it off the ground

 

[Gearbanger 101]

Tubular K-Member, weight transfer, suspension work, traction and power. Most Termi's I see don't seem to get them off the ground untill they're running at least mid/low-10's. So it's gonna be tough without getting creative.

 

[tag4car]

Tubular K-Member, weight transfer, suspension work, traction and power. Most Termi's I see don't seem to get them off the ground untill they're running at least mid/low-10's. So it's gonna be tough without getting creative.

that's pretty much what i thought... ughhh

 

[H0SS302]

+ u got to factor in the pure weight of the car.. 4vs are some portly cars. iv seen 2vs get lifted a little just from good weight transfer and suspension setup, and some minor mods.