I have an innovate lc-1 and a normal o2 sensor.
This is the history
the lc-1 was working right with tweecer. I could enter a 2 volt for high/low on lmprogrammer and get a solid number. Now when I do that it does not stay a solid number. It will go from like 13.5-13.75
Sent that off and got a new one, still have the same problem.
A few days ago I datalogged my hegos and kams. Both stayed at .024 and 1, and it would not go into CL. I started thinking maybe I messed something up when hooking up my new lc-1.
Could these problems be related? I have my system, heater, and black wire (some type of ground?)l wired under the kickpanel. They are on the same thing, but not touching.
just did some testing
if I turn the key on and log my HEGO 2 goes from 1.2-1.27ish but HEGO 1 is .024. When I start the car they both are .024
This is the history
the lc-1 was working right with tweecer. I could enter a 2 volt for high/low on lmprogrammer and get a solid number. Now when I do that it does not stay a solid number. It will go from like 13.5-13.75
Sent that off and got a new one, still have the same problem.
A few days ago I datalogged my hegos and kams. Both stayed at .024 and 1, and it would not go into CL. I started thinking maybe I messed something up when hooking up my new lc-1.
Could these problems be related? I have my system, heater, and black wire (some type of ground?)l wired under the kickpanel. They are on the same thing, but not touching.
just did some testing
if I turn the key on and log my HEGO 2 goes from 1.2-1.27ish but HEGO 1 is .024. When I start the car they both are .024