Spongy pedal

Z06killinSBF · Jan 6, 2008

Ok, I just installed the Granada swap on my 'Stang. Everything of coarse was harder than it had to be. After swapping nearly all my lines and putting in a new distibution block, the pedal sits really low and is really soft. I cant seem to properly bleed the brakes although I cant find any leaks and everything is tight. Suggestions?

D.Hearne · Jan 6, 2008

Bleed em some more. Or if you have a power booster, check it for leaks.

Rusty67 · Jan 6, 2008

Did you go from non-power to power brakes ?

enferno · Jan 6, 2008

how long is your pushrod?

it could be too short of a pushrod.

Z06killinSBF · Jan 7, 2008

No booster and I used the pushrod from the kit. The one from my old MC doesnt remove.

Rusty67 · Jan 7, 2008

Did you bench bleed the new MC ?

D.Hearne · Jan 7, 2008

Did you change the brake hoses when you did the swap?

wild70stang · Jan 8, 2008

You may need to adjust the distance of the brake shoes. When I replaced my brake system I had to re-adjust the shoes. If you have a booster make sure its rod length is set properly, there is a device that is (forgot what its called) that sets the rod within a 1/16" of an inch from the MC. If the rod is set too short it can cause the pedal to feel spongy. As Rusty said, you also need to bleed the MC as air is trapped in the valve and needs to be released before installing on the car. There are plenty of websites that offer advice on Bench Bleeding.

Z06killinSBF · Jan 9, 2008

Bleed the MC, mostly new lines, and I noticed the rod is adjustable so I adjusted the rod and now I just need to bend one more new line as I think the flare was messed up on it.

Spongy pedal

Z06killinSBF

Member

D.Hearne

New Member

Rusty67

enferno

Member

Z06killinSBF

Member

Rusty67

D.Hearne

New Member

wild70stang

New Member

Z06killinSBF

Member

Similar threads

Spongy pedal

Member

New Member

Member

Member

New Member

New Member

Member

Similar threads

Privacy & Transparency

Privacy & Transparency