Starting problems...help!

Steve2kGT · Feb 17, 2004

I originally put this is in the SVT section, but you guys should be able to help as I think the electronics are the same.

http://forums.stangnet.com/showthread.php?t=425492

Steve2kGT · Feb 18, 2004

I'm sure some of you have had this problem before. I basically need to know what to try next? I don't want to take it to the dealer for fear of getting screwed on some other repair... I found an ignition module part after calling Kragen. I found it online for about $169 or so. But I don't know the electrical system of the cobra, so not sure what the operation of this part is. If it could possibly be my culprit, or you can tell me some possiblities I will try to fix it myself.

As a last resort I'll take it in.

COramprat · Feb 18, 2004

Not real sure but just a suggestion. You may have a bad coil pack. Give me a minute and I'll see if I can find out how to check them.

Here it is...
Ignition off...disconnect the elect. connector from coil (there are 2 of them). Using an ohm meter, connect the positive lead to the center of the primary term and the negative to the outside terminal. Reading should be 0.3 to 1.0 ohms. Then check the secondarys where the plug wire connect. Each is paired to a companion cylinder so connect the leads from 7-4, 8-2,1-6, and 3-5. Reading should be6.5 to 11.5 K-ohms. If any readings are bad, then it is a bad coil.

At least you can rule out the packs by doing this. All this info was found in Haynes manual. It also says there could be a problem with fuel management system but it is a pretty invlved check.

Starting problems...help!

Steve2kGT

Steve2kGT

COramprat

...I can take it. I think.

Similar threads

Starting problems...help!

Steve2kGT

Steve2kGT

COramprat

...I can take it. I think.

Similar threads

Privacy & Transparency

Privacy & Transparency