I got my used tri ax in today and when I installed it the ball part that goes into the shifter mechanism will slip out of it with the shifter all the way bolted down but the stock shifter does not do this. I made sure it went into the mechanism and it will stay in there for a minute then it will just pop out and you can move the shifter all around with out it going to any gear. Anyone have any ideas or did I just get the shaft?
Steeda tri ax problem
- Thread starter drewzx3
- Start date
GTA_V6_Mustang
Active Member
I am sure others here can help you more but if you can get up some pics it may be easier to help you out.
steeda makes about 5 different tri-ax shifter to fit different years and trans do you know {since you said you got it used} that what you have works correctly in your trans?
this might be helpful
http://www.steeda.com/products/drivetrain_shifters.php
this might be helpful
http://www.steeda.com/products/drivetrain_shifters.php
I dont know the differences in the shifter models myself. Doesnt a 3650 come in the last batch of GT's (01 or 02+)? If so, maybe ask in that sub-forum for the guys to measure their shifter shaft length (or whatever it is that might be different) so you can compare yours to theirs.
:OT: Guero, I opened the door for you with all this talk of shafts and comparing lengths. Let's have it.
:OT: Guero, I opened the door for you with all this talk of shafts and comparing lengths. Let's have it.
Not sure on this, someone chime in here, the bottom part of the stocker and the tri-ax should be that same shouldnt it, the short throw comes from the shorter shifter handle and a different mechicanical advantage. I would think in order for it to work the bottoms would have to be the same. Agian someone come in on this. Compare your shifters and see what it looks like??
True 5.0
Member
Similar threads
