You can see in my Sig I have a built motor but the only thing that I did not replace when I built this motor was my stock oil pan. I cleaned the crap out of it and used new gaskets but after a few years this thing is leaking (or the main seal is leaking not sure yet) regardless this winter I am pulling the motor and im going to just over haul the bottom end with new gaskets and seals but I would also like to maybe go with an 8qt Oil Pan. I was looking at a Milodon but I cant seem to find one that works for a 95' so anyone have any suggestions on a decent pan to use? or should I just replace the stock one with a replacement one and have it painted ford blue to match my block. Also Gasket Suggestions as well. thanks