Hey guys,
Lets see if we can figure this project out. I picked up an Eaton M90 Supercharger off a Ford Supercoupe. My plans are to install the supercharger on my 89 LX 5.0. I have an idea with the intake, where I am going to relocated it to the other side of the car. The only problem that I am running into is the lower manifold. What I was thinking is using a carburator manifold with a little rise so it clears anything in its way, that will fit a 302 block. Does anyone know of a carburator manifold that I can use for this project? I know that Ford went to fuel injection in 1986 and pre 1986 it was carburated. I have a pic of a Saleen M90 that is made for a 89-93 stang, but Saleen has not responded to my email on the lower manifold. I know I have to change my injectors. Any suggestions?
Lets see if we can figure this project out. I picked up an Eaton M90 Supercharger off a Ford Supercoupe. My plans are to install the supercharger on my 89 LX 5.0. I have an idea with the intake, where I am going to relocated it to the other side of the car. The only problem that I am running into is the lower manifold. What I was thinking is using a carburator manifold with a little rise so it clears anything in its way, that will fit a 302 block. Does anyone know of a carburator manifold that I can use for this project? I know that Ford went to fuel injection in 1986 and pre 1986 it was carburated. I have a pic of a Saleen M90 that is made for a 89-93 stang, but Saleen has not responded to my email on the lower manifold. I know I have to change my injectors. Any suggestions?