Tach not working

E

EZMachN

New Member

Sep 29, 2004

13

0

1

Tuscaloosa, Al

Jul 22, 2006

#1

• Jul 22, 2006

• #1

I justed installed my Auto Gauge tach. I am using a MSD 6al. Everything is hooked up and light works. But when I crank the car the needle shoots to the shift light point and sits. Like if I set it to 6k it will go from 0 to 6k when cranked and sit there. I have my red wire (key-on wire) tapped into my #11 Fuse (Radio). Do I need to put the red wire somewhere else or get a tach adapter?

 

M

Mike92GT

Founding Member

Jan 23, 2002

583

0

0

Florida

Jul 22, 2006

#2

• Jul 22, 2006

• #2

Do you have the green wire plugged into the tach terminal on your 6A box?

 

E

EZMachN

New Member

Sep 29, 2004

13

0

1

Tuscaloosa, Al

Jul 22, 2006

#3

• Jul 22, 2006

• #3

Yep, its plugged in

 

Roland69

Sergeant Tangnet

Sep 17, 2005

2,867

3

58

Port Elgin, Ontario

Jul 22, 2006

#4

• Jul 22, 2006

• #4

is it switched to RPM recall. sounds like it is

 

E

EZMachN

New Member

Sep 29, 2004

13

0

1

Tuscaloosa, Al

Jul 22, 2006

#5

• Jul 22, 2006

• #5

Doesn't have recall. This is the one I have.

 

Attachments

• 233904.webp

  28 KB · Views: 122

Roland69

Sergeant Tangnet

Sep 17, 2005

2,867

3

58

Port Elgin, Ontario

Jul 22, 2006

#6

• Jul 22, 2006

• #6

is it in shift light set mode

 

E

EZMachN

New Member

Sep 29, 2004

13

0

1

Tuscaloosa, Al

Jul 22, 2006

#7

• Jul 22, 2006

• #7

I didn't know there was a "shift light mode" ? I thought that mode was when you turn your car on but not crank, then turn off and crank and your good?