Last summer I noticed both my volt and temp gauge stopped working at the same time and everything else was functioning fine. Over the winter I did some upgrades and replaced all my engine sensors and did some diagnosing.
Grounded out the wire going to temp sending unit and gauge didn’t move
Checked ohm from sending unit wire to #8 pin on white ten pin connector and I have 5ohm
I then checked the female side of the #8 pin connector to the wiring at the dash cluster and it showed 6ohms
Alternator still charges fine and car doesn’t over heat as I have a mechanical temp gauge but it’s driving me nuts that these two gauges don’t work.
I’ve checked all my grounds numerous times and have even added several more. I don’t have any blown fuses and everything in the car works and functions like new except for the volt and temp gauge.
Any ideas? Does anyone have a dash cluster schematic for a 93 mustang
Grounded out the wire going to temp sending unit and gauge didn’t move
Checked ohm from sending unit wire to #8 pin on white ten pin connector and I have 5ohm
I then checked the female side of the #8 pin connector to the wiring at the dash cluster and it showed 6ohms
Alternator still charges fine and car doesn’t over heat as I have a mechanical temp gauge but it’s driving me nuts that these two gauges don’t work.
I’ve checked all my grounds numerous times and have even added several more. I don’t have any blown fuses and everything in the car works and functions like new except for the volt and temp gauge.
Any ideas? Does anyone have a dash cluster schematic for a 93 mustang