Just bought new tie rods today and looked at my cliltons and found that they have not install instructions. Any one know what needs to be done?
Dan Lafley
96 GT
well i can't imagine its much different then any other tie rod. just undo the castle nut after u remove the cotter pin and pry it downward. then twist it off. you may have to use a couple of wrenches. then instal new one as close as u can to the amount of threads the old one was set up at and drive to a lignment shop and get a front alignment. I have never been so luck as to not have to go to a shop after replacing a tie rod end.
its pretty easy.. i did the outer tie rods, if u really want i could take pictures of my chiltons directions and send you pictures. i am not sure if thats legal.