Timing Question!

armadillon

New Member
Jul 19, 2007
10
0
0
Hey, If you have a stock 1989 302 (MAF, stock E7 Heads, stock cam) and replace the 1.6 pedestal rockers with 1.7 roller rockers, how does it effect your timing?

Cuz that's what I did on my car! I'm having a weird surging/idle problem, and I read the "Surging Idle Checklist", but I need to know how the rockers are affecting my car's timing before I do some of that stuff.

Question 1: What is the normal ideal timing for my car?

Question 2: What should it be at now?
 
I have about the same setup as you and installed 1.7s w/ no problems, I'd look elsewhere for the cause. If you have a cold air intake try clocking (rotating) the MAF sensor, they get funny readings off the curve in that pipe sometimes I know it affected how mine idled alot.
 
Installing a set of rocker arms doesn't affect engine timing at all.

If the only variable between your motor running smoothly and now surging/rough idle was the rocker arm install, than more than likely you improperly installed the rockers and that is what's causing your motor to run rough.

Tell us how you installed your rockers, and we can tell you if you screwed it up or not. You have no idea how many people think installing rocker arms "to spec" just means removing all the rocker arms and tightening the new ones down. Did you do that, or did you make sure each piston was at TDC with both valves closed before you torqued down the rockers?
 
THanks for y'alls info so far, it's been a little helpful..i think =)

The way I installed the rockers:

I replaced them one at a time, making sure each one was at TDC and checking valve lash. I had to use shims between a lot of the rockers, it was kinda strange, because on some intake rockers I would use a thick AND thin shim, but on others i would use only a thick.

I know this is kinda fuzzy and really ahrd to describe without y'all have actually being been there (WTF, do I know english?) but I'm trying =)

I think the shims were .003 and .006 and I was torquing them to spec and at the same time listening for when the valves popped open.

The entire time that the group of 4 people I was with were installing them, I was skeptical on the install, so that's probably a good sign.

In the mean time, it seems to be running pretty well.

If it's running ok with only a bit of a weird idle, are there any impending doom(s) I should be aware of?
 
Running well means that the idle will be at 900-950 for about 10 seconds and then jump to about 1000 or 1050 for 10 seconds. Maybe I just can't identify a NORMAL idle since every car I've ever had has had an abnormal one.