Timing & Suspension Woes...need some input.

Mike86Stang

Advanced Member
Apr 11, 2000
10,296
0
77
Red Lion, PA
t with the timing, I tried backing my timing down to 10* b/c i'm only running 87 octane with my 19's & the car ran like crap. It had no power bucked & popped in the exhuast started to over heat & the headers started glowing orange. So i put the timing back where I had it at 18* & it runs alot better, no over heating no glowing headers all on 87 octane. This isn't making any sense to me. The car should be detonating it's butt off, but won't even run at base timing. I checked the dampner for walking (I marked it when it was new) & it hasn't budged. So the timing marks are as accurate today as they were about 2 years ago when I replaced it. Should I just accept the fact the engine needs alot of timing??? It seems to me something must be wrong for it to need all that timing & not run on base time. WTF

Another thing is I've been getting more than my normal share of wheel hop out of the rear axle. It also feels like it "wiggles" under the car when under WOT. If I ease from a stop I eigther get a pop/clunk sound out of the right rear or I get wheel hop. I've had the quad shocks off the car for quite sometime now & has not made a diffrence up until now. The quads have been off for going on about 2 years. I looked at the bushings & they look fine beside squeeking or groaning over the occasional bump. I looked at the torque boxes & I don't see any tares or seperation from the frame.
I don't know what else to look for.

Any ideas fellas/ladies???

TIA
MIKE
 
Timing is Ok. I would check with Steeda to get the most out of your cam. some cams require more advance to work well, that may be why your car runs bad at stock timing. As for your suspension, the stock setup has all rubber bushings, and your lower contol arms are mounted to the sheet metal of the body. If you are going to keep the car where it is at as far as power you "might" be okay with changing the bushings. If you are planning to add more power (torque), you may want to invest in a good set of lower control arms and torque box reinforcements along with the polyurethane bushings.
Trust me. It started with popping, then the next thing I know I had three one inch tears in one of my torque boxes, and that was with my bolt-ons for my stock motor (no longer using), and no power adder. I also do a lot of drag racing (street and track).