Alright, I'm almost done putting my motor together on the stand, and im gona swap a few things from the motor in the car now....SO I have to pull that one out first, use the accessories, starter....that kinda stuff....
What are some good tips for pulling the motor and putting the other back in...
I put a new oil pump, water pump and timing chain on the newer motor...
Setup is gona be: Heads cleaned, removed EGR bumps, lightly ported, tmoss ported lower, pullies, full exhaust, and finally....3.73's!
should be a fun car once its all together! any tips would be helpful cus after this i gotta put a motor in yota!
What are some good tips for pulling the motor and putting the other back in...
I put a new oil pump, water pump and timing chain on the newer motor...
Setup is gona be: Heads cleaned, removed EGR bumps, lightly ported, tmoss ported lower, pullies, full exhaust, and finally....3.73's!
should be a fun car once its all together! any tips would be helpful cus after this i gotta put a motor in yota!