Here is my deal.I did not realize there was a proper way of installing the torque convertor.I know my bad there.Anyway I put the new flywheel on then bolted the convertor to the flywheel.Then picked the tranny up and slid it on the back and just wiggled it a little till the tranny touched the motor.Then I bolted it up and put it in the vehicle.Now when I got everything together the motor acts like it is locked up after I spun it over for about 2 seconds.Then when I went to spin it again it does not move..Cold the tranny be bound up from putting it in the wrong way?I just now read something about 3 step process on installing it.thx for any help