Hey guys, hoping someone has some advice to help me.... I dropped my transmission to try and fix an oil pan leak and now I'm putting it all back together. I got the transmission back in and now I'm trying to get the crossmember back in and it will NOT line up... I had this problem a few months ago when I did all this and I was finally able to get the stock crossmember back in with hours of pry bars and hammers. This time around I bought a Stifler's tubular crossmember hoping that would solve the problem.... but it doesn't. I think my issue is that crossmember mount on the driver's side is smushed up a bit (I think from many years ago when I was younger and careless and jacked it up incorrectly...) which I think messed up the alignment. Attached are some pics to help illustrate what I'm saying.... so does anyone have any advice on how I can proceed? Can I elongate the mounting holes to make it match up? Will that change the angle of the trans and driveshaft and cause vibrations? Is there something temporary I can do so that I can get it to a body shop to have them put new crossmember mounts in (I assume they can do that right?)? Any help would be appreciated... thanks guys!