Trouble Code 12? fix?

Ok, I think it's fixed.

I kept getting the code 12. The Actron CP9145 scantool that I was using couldn't run the tests because it couldn't control the rpm. This was caused by the IAC not working correctly.

I cleaned the IAC, then I was getting a code "0". It says it doens't know what the code is, but there is a problem. Anyway, I got a new IAC and took a look at it. It turns out that the spring in the old IAC was about worn out. The plunger on the old one was very easy to move compared to the new one. I then replaced the old IAC and the code went away and the engine idles a lot better.

I bet it starts right up tomorrow.

have a nice day and thanks for the help

Jim Lane