ok, stupid question i know, but i am just starting to do my own work and this is probably the simplest place to start.
do i really have to take out the whole stop/turn signal assembly to replace a burned out turn signal bulb? seems like more than i should have to do for such a simple thing.
Remove the radiator cover over the headlight if you have one on. There is a 10 or 11mm nut on the center of the corner lens holding it in (behind the headlight).
the rear lights? yes you have to remove the whole assembly. its a pita but not that bad. there are 4 11mm or 7/16" (same size) on each light then it pulls straight back. you will have to remove the rear paneling to get to it