does anyone know if the stock "cobra powered by ford" valve covers will fit with comp cams roller tip rockers on edlebrock performer RPM heads?
valve cover clearance
- Thread starter mustangmike6996
- Start date
PoppyMod
Member
Hi,
I'm running the Comp Ultra gold roller rockers on TFS heads. My V/Cs are "Mustang powered by Ford" cast aluminum. I had to remove the oil baffles and grind down all of the casting bosses. Later, I found dbl thick gaskets could be used, as well. I wanted to retain my V/Cs as I didn't like any of the alternatives.
Good Luck!
I'm running the Comp Ultra gold roller rockers on TFS heads. My V/Cs are "Mustang powered by Ford" cast aluminum. I had to remove the oil baffles and grind down all of the casting bosses. Later, I found dbl thick gaskets could be used, as well. I wanted to retain my V/Cs as I didn't like any of the alternatives.
Good Luck!
Falcon79
Active Member
PoppyMod
Member
Hi,
Check this: http://www.scegaskets.com/Ford/289-...Gaskets/tc259844//page/1/checkForLanding/true. Good Luck!
Check this: http://www.scegaskets.com/Ford/289-...Gaskets/tc259844//page/1/checkForLanding/true. Good Luck!
hmmm will the tall ford motorsports valve covers fit? or the Boss 302 tall style would be cool if i could find them somewhere for a good price
PoppyMod
Member
Hi,
More than likely, the "tall" will e fine. After all, that's why they were successful.
i was looking at these http://www.summitracing.com/parts/FMS-M-6582-A341R/?rtype=10
i found them for 125ish new a few other places. i could do the Ford Racing or the Boss Ford Racing...
the Boss covers look a bit nicer....
i just really like the tall cover and angled flat top look
i found them for 125ish new a few other places. i could do the Ford Racing or the Boss Ford Racing...
the Boss covers look a bit nicer....
i just really like the tall cover and angled flat top look
Loup-garou
Founding Member
You could also go with a set of adapters and some FE "pent roof" cast ("Cobra Le Mans") valve covers like the Factory Five Cobra guys do.
Just got my "BOSS" style v/c's in the mail today... they look sweet on my aluminum heads! can wait to see them in the car!
Similar threads
