Vibration after aod swap

[mhjo]

Theres a rumnble/vibrtation in the driveline after the swap. This is most severe in 3d.

Info: The axle was not shortened, but we used a shorter yoke insead. Tips?

 

[JonK]

Info: The axle was not shortened, but we used a shorter yoke insead. Tips?

I take it you meant to say the driveshaft was not shortened but the trans yoke was shortened from the C4?

Did you have the driveshaft balanced before reinstall?
New ujoints?

What trans support did you use?
New C4 trans mount?
Just trying to figure out if your driveline angle is correct.
Jon

 

[mhjo]

I take it you meant to say the driveshaft was not shortened but the trans yoke was shortened from the C4?
=Yes


Did you have the driveshaft balanced before reinstall?
=No

New ujoints?
=No

What trans support did you use?
New C4 trans mount?
= I will check!

Just trying to figure out if your driveline angle is correct.
Jon

=Thanks, you just gave me a good check list!, THANKS!!