mhjo Founding Member Nov 9, 2000 490 0 17 Oslo, Norway Apr 24, 2011 #1 Apr 24, 2011 #1 Theres a rumnble/vibrtation in the driveline after the swap. This is most severe in 3d. Info: The axle was not shortened, but we used a shorter yoke insead. Tips?
Theres a rumnble/vibrtation in the driveline after the swap. This is most severe in 3d. Info: The axle was not shortened, but we used a shorter yoke insead. Tips?
JonK Member Jun 6, 2007 276 0 16 Nashville (Smyrna), TN Apr 24, 2011 #2 Apr 24, 2011 #2 mhjo said: Info: The axle was not shortened, but we used a shorter yoke insead. Tips? Click to expand... I take it you meant to say the driveshaft was not shortened but the trans yoke was shortened from the C4? Did you have the driveshaft balanced before reinstall? New ujoints? What trans support did you use? New C4 trans mount? Just trying to figure out if your driveline angle is correct. Jon
mhjo said: Info: The axle was not shortened, but we used a shorter yoke insead. Tips? Click to expand... I take it you meant to say the driveshaft was not shortened but the trans yoke was shortened from the C4? Did you have the driveshaft balanced before reinstall? New ujoints? What trans support did you use? New C4 trans mount? Just trying to figure out if your driveline angle is correct. Jon
mhjo Founding Member Nov 9, 2000 490 0 17 Oslo, Norway Apr 25, 2011 #3 Apr 25, 2011 #3 I take it you meant to say the driveshaft was not shortened but the trans yoke was shortened from the C4? =Yes Did you have the driveshaft balanced before reinstall? =No New ujoints? =No What trans support did you use? New C4 trans mount? = I will check! Just trying to figure out if your driveline angle is correct. Jon =Thanks, you just gave me a good check list!, THANKS!!
I take it you meant to say the driveshaft was not shortened but the trans yoke was shortened from the C4? =Yes Did you have the driveshaft balanced before reinstall? =No New ujoints? =No What trans support did you use? New C4 trans mount? = I will check! Just trying to figure out if your driveline angle is correct. Jon =Thanks, you just gave me a good check list!, THANKS!!