vibration after head gasket fix

valdre331

New Member
Dec 6, 2006
15
0
0
hello i wondering if anyone can help me out. i blew a head gasket a few weeks ago. i replaced it, now the car has a very hard time starting. i have to hold the gas down to keep the rev to at least 2000 rpm. when it start to warm up the car then idle fine. i can see that i have a vaccum leak, and the car smell like fuel. it also vibrates when i give it a little gas. at idle it seem fine, but at 2000 or more its got this strange vibration. nothing violent, just a little. i wondering if i minght have bent a rod when i blew the head gasket. any help would be appriciated. i can't think of anything else right now that would help give an idea of what it is. if you guy can think of question to help figure out what it would be just ask. thanks
 
The most common problem i have had was the intake to head gaskets getting a little off. but if you are sure all of your gaskets are seald properly check all vaccum lines for proper connection and make sure they are not cracked or broken.

here is a diagram you can use to trace all of your lines. hope this helps.

88Stang5.0Vacuum.gif
 

Attachments

  • 88Stang5.0Vacuum.gif
    88Stang5.0Vacuum.gif
    14.3 KB · Views: 179
do you think that the vibration, and hard start could be cause by that? when i rev and let the rev come back down its kinda sound like something is unbalanced.
 
If you have a vacuum leak, get that resolved first before trying to chase down any other issues. That could very well be the only problem if the leak is bad enough.
 
i checked the firing order, i have not done the compression test yet. the car at a friend house so i have to haul the tools there. the gasket blew cause i think the heads were over torgue. i have a shop build the engine for me, and i think they over torgue the head bolts. it also might have also been that it lean out at high rpm. i can't really tell cause when i opened it up the gasket got messed up. i did have the heads check to make sure they were still straight with out crack. i think that the vaccum leak is cause the lower intake did not sit right. before the i have 20 in of vac. now its about 8in.