Recently my car has developed a stalling issue. So in an attempt to narrow down the causes I dumped the computer codes. One of the codes I recieved was code 66 MAF below minimum test voltage.
I did a quick test and disconnected the MAF harness. Nothing happened. I took this to mean the MAF was in fact dead. I went on to other chores (cleaning the IAC and resetting the idle and TPS). Later I came back to test the MAF with a voltmeter. To my suprise I got a reading of about 12-13 volts on pins A and B and a reading of about 1 volt on C and D at idle. So I decided to disconnect the MAF again to see what happened. The engine stumbled and started to run like crap.
Could this on and off again failure of the MAF be a sign that it is getting ready to die? Should I go about replacing it anyway? Also could this be the cause of my stalling issue? Also the car seemed to run fine when I took her on a test run. She usually stalled atleast once if left to idle for to long or taken on long trips. Don't know if this is an indication that the problem is solved however. I am afraid to go on long test drives.
I'm clearing the codes and I will see what comes up again if the problem resurfaces.
I did a quick test and disconnected the MAF harness. Nothing happened. I took this to mean the MAF was in fact dead. I went on to other chores (cleaning the IAC and resetting the idle and TPS). Later I came back to test the MAF with a voltmeter. To my suprise I got a reading of about 12-13 volts on pins A and B and a reading of about 1 volt on C and D at idle. So I decided to disconnect the MAF again to see what happened. The engine stumbled and started to run like crap.
Could this on and off again failure of the MAF be a sign that it is getting ready to die? Should I go about replacing it anyway? Also could this be the cause of my stalling issue? Also the car seemed to run fine when I took her on a test run. She usually stalled atleast once if left to idle for to long or taken on long trips. Don't know if this is an indication that the problem is solved however. I am afraid to go on long test drives.
I'm clearing the codes and I will see what comes up again if the problem resurfaces.