What hardware do I need for PI swap?

[speedfreak98r]

Ok, so I found the heads; Now I need to know everything that I will need to do the install; i.e. gaskets, nuts, bolts, whatever. I'd also like to know the approximate cost of all of this.

 

[speedfreak98r]

I already did a search for it, and couldnt find the info I was looking for.

 

[crabman98gt]

Jegs and Summit sell a Head changing kit that comes with head bolts, head gaskets, and header gaskets for 115.99.

You'll have to get a intake manifold gasket and a PI intake if you don't already have one.

 

[speedfreak98r]

how much do the PI intakes go for? new/used..

 

[crabman98gt]

Jegs and summit want $200

I got mine for 125, check the classified sections, With the new improved intakes coming out ($4-500) stock PI intakes should be poppin up soon if not already.

 

[four six]

remember that the PI intake needs to be taped and drilled for the second sensor, as the 99-04 GT only had one instead of two like the 96-98s

 

[96BlueStangGT]

how much do the PI intakes go for? new/used..

$149 new.

 

[DropTopPony]

Contact Randy S in the Ford Parts Forum area on Modular Depot. Tell him what you are doing and what you have and he will know exactly what you need. He has good prices also.
You can find the intakes used for @120. Look in the classifieds here and on Corral.net

 

[tomustang]

you can reuse your intake gaskets, just clean them off and check if they're not worn any, cheapest head changing kit i've found is at mod depot http://www.modulardepot.com/product_info.php?cPath=97_101&products_id=265

insted of tapping for second temp sensor you can use a T-fitting for both sensors into the one hole

 

[speedfreak98r]

Hmmm....Don't know what I would do without :SNSign:

Thanks a million for the help so far.. But what about plug wires, and such..

 

[speedfreak98r]

Will my aftermarket plenum, and throttle body fit the PI intake?

 

[tomustang]

yes

 

[MyEarsHurt]

Don't forget the timing cover gaskets (there are three seperate ones) and also if you have never replaced the exhaust gasket between the manifold and the midpipe on the passenger side then you may want to get a new one of those as well. Get a new thermostat while everything is apart, just to be safe, and the thermostat gasket as well.

 

[BlackenedSVT]

COMPLETE KIT (free shipping):

http://performance.parkwayfordga.com/2vheadswap.asp

you will need the heads, intake, cams, gaskets, all new head bolts (recommended), etc.



And i would recommend upgrading the cams, while you are doing this project.

 

[speedfreak98r]

I'm going with used heads, so I will basically need everything on the link except the heads?

 

[dollarbill]

You will need lots of little odds and ends. This link should help you. BTW you need a few diferent things to put Windsor heads on Romeo. http://www.eccentrix.com/members/46mustang/headswap.html