What RPM's is my stock tranny Designed to shift at?

avexhype said:

no.... the shift point should be where the car's horsepower peaks. its literally pointless to rev any far past that, youll be doing more harm than good, and might even slow you down if u go too far past and start dipping off into a higher rpm and lower HP curve. I see you have VT st.II cams, so look at your dyno sheet, wherever the HP curve reaches its peak, thats where u shift. If it keeps climbing after your redline, then shift right before you reach fuel/spark cut for optimal performance.

We dont have honda's guys, stop thinking like them.

Click to expand...

hotstang_46 said:

So I'm working with my sniper stuff and raising the stock redline which I found out was 5800rpm and would like to raise the WOT shift points on the tranny to 6200.

I wan't to be precise and don't know at exactly what rpm my tranny is scheduled to do it's different shifts at right now. My Sniper stuff doesn't give me the choice of entering the rpm...say 5800,5900 etc etc... The fields are +100, +200, etc etc. So that's why i need to know where they are stock...

Thanks

Click to expand...