Mustang5L5 That is…until I whipped out my Bissell Mod Dude Feb 18, 2001 43,372 18,120 224 Massachusetts Jan 14, 2008 #1 Jan 14, 2008 #1 Lenght is not the issue, but what thread pitch and diameter are the bellhousing to block bolts so i can pick up 4 to bolt a block to an engine stand.
Lenght is not the issue, but what thread pitch and diameter are the bellhousing to block bolts so i can pick up 4 to bolt a block to an engine stand.
Grn92LX Fidanza Man! Founding Member Jan 14, 2001 6,819 64 129 New York Jan 14, 2008 #2 Jan 14, 2008 #2 7/16"-14..same as head bolts.
5spd GT "the 5.0 owns all" Founding Member Aug 7, 2002 9,516 6 99 Arkansas Jan 14, 2008 #3 Jan 14, 2008 #3 Yep, that is what I have as well...
Mustang5L5 That is…until I whipped out my Bissell Mod Dude Feb 18, 2001 43,372 18,120 224 Massachusetts Jan 14, 2008 #4 Jan 14, 2008 #4 thanks
Grn92LX Fidanza Man! Founding Member Jan 14, 2001 6,819 64 129 New York Jan 14, 2008 #5 Jan 14, 2008 #5 Whatcha building?
Mustang5L5 That is…until I whipped out my Bissell Mod Dude Feb 18, 2001 43,372 18,120 224 Massachusetts Jan 14, 2008 #6 Jan 14, 2008 #6 I don't know yet
V v8only Active Member Jul 3, 2003 2,378 22 49 Jan 14, 2008 #7 Jan 14, 2008 #7 course thread, of course, and you'll need 3" of length, and maybe 2-3 washers on the end of each if you're using a harbor freight engine stand
course thread, of course, and you'll need 3" of length, and maybe 2-3 washers on the end of each if you're using a harbor freight engine stand