• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

What would cause shaky Maf Voltages while datalogging?

  • Thread starter Thread starter Black1987Stang
  • Start date Start date Dec 19, 2007

Black1987Stang

Active Member
Aug 22, 2004
1,422
0
37
Jersey Shore
Dec 19, 2007
#1
  • Dec 19, 2007
  • #1
While datalogging with my Tweecer R/t, I noticed the maf voltage was very unsteady it was ranging give or take like 1 full volt. Example, I'm steady cruising and the Maf voltage is ranging from 1.6-2.6. Normally I could get it to stay steady with a steady throttle, the corresponding sliding gauge that is above the maf volts shows it being shaky....What would cause this to happen? Only thing I can think to do is clean the maf....
Sean
 

vristang

15 Year Member
Mar 31, 2005
4,933
101
124
Seattle
Dec 20, 2007
#2
  • Dec 20, 2007
  • #2
This didn't happen before?

Have you done anything to the car lately?

Either dirty or a loose connection somewhere...
 

Black1987Stang

Active Member
Aug 22, 2004
1,422
0
37
Jersey Shore
Jan 13, 2008
#3
  • Jan 13, 2008
  • #3
If I went WOT the sliding bar graph would go ALL over, max out at 1500, go down to 300 back up again, all over. I put the stock meter back on and it was alot better, it was fine at WOT. Smooth and steady rise. I dialed in the maf and now it's smoothed out even more. I was guessing the shakiness was from the engine missing or hiccupping causing the difference in vacuum pulling in air across from the meter? Anyway I can test the meter electronics from a Pro-M 75mm myself. If it's not the problem I would like to sell it and get something better for when I put the S-trim and turbo on in the summer.
 
You must log in or register to reply here.

Similar threads

Engine Random Misfire at idle.
  • Gulftown980x
  • Jul 29, 2026
  • SN95 4.6L Mustang Tech
Replies
11
Views
616
SN95 4.6L Mustang Tech Jul 31, 2026
squeak93
Progress Thread Giving an abandoned 88 GT project a new chance at life
  • jaketractor
  • Jan 9, 2025
  • Fox 5.0 Mustang Tech
  • 2
Replies
27
Views
2K
Fox 5.0 Mustang Tech Jul 20, 2025
Noobz347
98 GT PI Swapped Engine Fires, Dies Immediately NOT PATS
  • MMccPerformance
  • Dec 2, 2023
  • SN95 4.6L Mustang Tech
Replies
3
Views
2K
SN95 4.6L Mustang Tech Dec 20, 2023
Yel2002GTAuto
Y
S
Cold start bucking - 94 5.0 GT
  • snrusnak
  • Oct 11, 2020
  • 1994 - 1995 Specific Tech
Replies
12
Views
6K
1994 - 1995 Specific Tech Jan 24, 2021
snrusnak
S
1
Electrical 1992 5.0 Running rich with surging idle (surge checklist has been done)
  • 1fstpnycb
  • Oct 3, 2018
  • Fox 5.0 Mustang Tech
Replies
8
Views
6K
Fox 5.0 Mustang Tech Oct 9, 2018
General karthief
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?