• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

What's causing this stupid problem?

  • Thread starter Thread starter Acid7711
  • Start date Start date Sep 20, 2005
A

Acid7711

Member
Sep 4, 2005
41
0
6
TN
Sep 20, 2005
#1
  • Sep 20, 2005
  • #1
About a week ago, I was randomly seeing a check engine light that would flash on and then go back off really quick usually. I noticed whenever I was giving it a bit more gas than usual (tiny bit) it liked to come on, and when I hit the clutch, a second later it would usually flash back off. Sometimes it would stay off for days, other times it would stay on for like 10 minutes then just randomly come on. I pulled the code, turned out it was a code 32. I cleaned out the ERG valve with tbi cleaner, cleaned out the holes in the EGR spacer and put it back together with a nice new gasket and finally setset the computer. Days went by and I didn't see the dreaded CEL come back on until last lastnight I was driving home and it flashed it's evil face at me again then dissapeared just as quickly. Driving home from school today, I noticed it once more. I pulled the codes and got a code 31 this time instead of a code 32 like before. What's causing this and how do I stop it? It doesn't seem to be doing anything besides annoying me.


Thanks for any advice anyone can offer

31 EVP - (O, R, M) EVP signal is/was out of range -
EVR - (O, R, M) EVP signal is/was low -
PFE - (O, R, M) PFE signal is/was low -
 

SQUEEZE&STROKE

New Member
Jun 24, 2005
0
0
0
SOUTHERN CA
Sep 20, 2005
#2
  • Sep 20, 2005
  • #2
How many miles on the car? Have you changed the O2 sensors recently. My car did the same thing ( on and off and on again). After I changed the o2's it was great!
 
A

Acid7711

Member
Sep 4, 2005
41
0
6
TN
Sep 20, 2005
#3
  • Sep 20, 2005
  • #3
It's got 90k on it. I JUST bought the car, so I don't know if the o2's have ever been changed. This weekend I went on a crazy maint fit though. Pcv valve and mesh filer thingie, tps/idle set, plugs (gapped at 0.05), wires, cap and rotor, fuel filter, oil, trans fluid, cleaned the maf screen, cleaned the air filter, and new optima battery.

I've done just about everything except o2's and that's because I had to order another one because the place only had one instock. I ordered another, and have one now. Thursday I'm going to put them both in and stuff. I know everything is pretty much done except the rear diff fluid that I need to change.

That would be nice to get that stupid CEL to go away. It's really annoying at night time. Plus it's always in the back of your mind "Somethings wrong with me"
 

jrichker

StangNet's favorite TOOL
In Remembrance. Thank you for your contributions
Mar 10, 2000
27,512
2,813
234
Dublin GA
Sep 20, 2005
#4
  • Sep 20, 2005
  • #4
CODE: 31 (KOEO) - EVP circuit below minimum voltage. Vref (5 volt reference voltage supplied by the computer) missing or broken wire or bad connection in circuit. Use a DVM to check for 5 volts on the orange/white wire. If it is missing, look for +5 volts at the orange/white wire on the TPS or MAP sensor located on the firewall near the center of the car. Use the black/white wire for the ground for the DVM.
With the sensor removed from the EGR and still connected, press the plunger and watch the voltage change on the brown/lt green wire. Pull the passenger side kick panel and measure the voltage at the computer. You will need to remove the plastic cover over the wires and probe them from the backside. A safety pin may prove very useful for this task. Use pin 27, EVR input (brown/lt green wire) and pin 46, signal ground (black/white wire) to measure the voltage. The orange/white wire is Vref and should always be 5 volts -/+ .25 volt. Be sure to measure Vref at the EGR sensor to rule out any broken wires or bad connections.
 
You must log in or register to reply here.

Similar threads

P
Electrical 1988 GT Wrong Cluster- causing electrical issues?
  • pindude80
  • May 6, 2025
  • Fox 5.0 Mustang Tech
Replies
3
Views
444
Fox 5.0 Mustang Tech May 6, 2025
pindude80
P
Tuners come on inside
  • squeak93
  • Feb 13, 2026
  • SVT Tech Forum
Replies
1
Views
374
SVT Tech Forum Feb 20, 2026
squeak93
J
Thanks for the information on codes 31,34,44 and 94!
  • JK86LX50
  • Mar 5, 2025
  • The Welcome Wagon
Replies
3
Views
375
The Welcome Wagon Aug 5, 2025
gkomo
P
2000 GT Random Power Loss
  • Pinellas50
  • Mar 9, 2026
  • SN95 4.6L Mustang Tech
Replies
4
Views
439
SN95 4.6L Mustang Tech Mar 23, 2026
Pinellas50
P
T
Drivetrain TREMEC TKX 1–2 Grinding Issue at ~4,000 Miles + Poor Warranty/Customer Service Experience
  • Ttopfoxguy
  • Oct 10, 2026
  • Fox 5.0 Mustang Tech
Replies
5
Views
319
Fox 5.0 Mustang Tech Oct 15, 2026
JMG9350
J
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?