• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

wheel whoble

  • Thread starter Thread starter cheddarbacon
  • Start date Start date May 2, 2005
C

cheddarbacon

New Member
Apr 17, 2005
82
0
0
May 2, 2005
#1
  • May 2, 2005
  • #1
Hey guys i have a driver side rear wable i need to know what are some causes of this happing?
 

88stangmangt

Active Member
Nov 25, 2003
2,332
1
48
Stafford,VA
May 2, 2005
#2
  • May 2, 2005
  • #2
bad wheel bearing.
 

ninjacoupe

New Member
Jul 6, 2003
174
0
0
NY
May 2, 2005
#3
  • May 2, 2005
  • #3
1) Loose rim . Usually pretty noisy

2) Bent rim. Tire and rim will wobble together

3) Bent axle flange. Tire and rim will wobble together

4) Slipped belt inside tire itself. Tire will appear to wobble on the rim

5) Too big/improperly mounted tire on rim. Tire will wobble around rim.

Jack rearend place socket on ground and rotate the wheels slowly and see.
 

88stangmangt

Active Member
Nov 25, 2003
2,332
1
48
Stafford,VA
May 2, 2005
#4
  • May 2, 2005
  • #4
well the easiest way to tell is...jack up the rear....grab the tire at 4 and 9 and see if you can shake it back and forth......if it doesnt move that way then check to see if the lugs are loose...either way it is super easy to find the culprit.IMO i would put my money down that it is the wheel bearing..since you would have long known the problem of a bent rim.
 

Michael Yount

Mustang Master
Apr 10, 2002
9,039
6
79
Charlotte, NC
May 2, 2005
#5
  • May 2, 2005
  • #5
The car being banged hard into a curb or a sizable pothole will bend wheels, axle flanges and pop a belt inside the tire. It's actually quite common to find vehicles with bent wheels.
 
I

I Got Shotgun

New Member
Mar 30, 2005
7
0
0
May 2, 2005
#6
  • May 2, 2005
  • #6
Yeah i had the same problem. I took it to a belle tire and they did a free inspection. I had a bad inner and outer tie rod on the passenger side wheel. Had to replace them on Sunday and I just got back from getting an aligment done. Its handling perfect now!
 

Michael Yount

Mustang Master
Apr 10, 2002
9,039
6
79
Charlotte, NC
May 2, 2005
#7
  • May 2, 2005
  • #7
...although bad tie rods probably won't make it wobble on the back....
 

Zero_chance

Founding Member
May 29, 2001
1,244
7
59
Maricopa, AZ
May 2, 2005
#8
  • May 2, 2005
  • #8
Id check the wheel bearing first. Were lucky and dont have sealed bearings. If it aint totally shot, repack it with grease and tighten it back up. Or just tighten it back up if you dont feel like getting dirty. If it s not the bearing, then Im pretty sure every other possibility it could be has been covered. Just go through them all until youve eliminated everything.
 

88stangmangt

Active Member
Nov 25, 2003
2,332
1
48
Stafford,VA
May 3, 2005
#9
  • May 3, 2005
  • #9
Zero_chance said:
Id check the wheel bearing first. Were lucky and dont have sealed bearings. If it aint totally shot, repack it with grease and tighten it back up. Or just tighten it back up if you dont feel like getting dirty. If it s not the bearing, then Im pretty sure every other possibility it could be has been covered. Just go through them all until youve eliminated everything.
Click to expand...
thats why i said that is where i put my money the problem is.
 

ninjacoupe

New Member
Jul 6, 2003
174
0
0
NY
May 3, 2005
#10
  • May 3, 2005
  • #10
88stangmangt said:
thats why i said that is where i put my money the problem is.
Click to expand...

So he should pull the rear cover off to get the c/clip out,Pull the wheels and brakes, then pull the axles to check the bearing thats pressed into the housing and not packed with grease ? Interseting.
 

88stangmangt

Active Member
Nov 25, 2003
2,332
1
48
Stafford,VA
May 3, 2005
#11
  • May 3, 2005
  • #11
ninjacoupe said:
So he should pull the rear cover off to get the c/clip out,Pull the wheels and brakes, then pull the axles to check the bearing thats pressed into the housing and not packed with grease ? Interseting.
Click to expand...
never said anything about that...for sum reason i dont know why im thinking he is talking about the front........lol.....im burnt up....
since im on the right page now...and he hasnt written back he prob has a toasted rim either way i hope to god he can figure it out...
 
M

Mike Erickson

New Member
Aug 25, 2004
5
0
0
Montana
May 4, 2005
#12
  • May 4, 2005
  • #12
Wheebles whobble!!!!

HeHe,Sorry I had to...
Brought back to my childhood!
You'll have to be over 30 to know what I'm talking about.
 
You must log in or register to reply here.

Similar threads

Suspension Is somethig Wrong Here?
  • Icemanxxxv
  • Jul 11, 2026
  • Fox 5.0 Mustang Tech
Replies
5
Views
218
Fox 5.0 Mustang Tech Jul 11, 2026
AeroCoupe
Engine A/C QUESTION
  • Mindseye007
  • Jun 5, 2025
  • Fox 5.0 Mustang Tech
  • 2 3 4
Replies
60
Views
3K
Fox 5.0 Mustang Tech Jun 22, 2026
nicholase
D
Exhaust Difficulty of fixing exhaust leak at manifold
  • dqureshi06
  • Aug 27, 2026
  • Fox 5.0 Mustang Tech
Replies
10
Views
343
Fox 5.0 Mustang Tech Aug 28, 2026
General karthief
E
  • Sticky
2003 Mustang GT convertible water leak
  • Eightiesrock1980
  • Jul 27, 2026
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
4
Views
380
1996 - 2004 SN95 Mustang -General/Talk- Jul 28, 2026
Noobz347
R
Fox Hydroboost conversion/proportional valve
  • RubyRedNotch
  • Jul 20, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
0
Views
123
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jul 20, 2026
RubyRedNotch
R
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?