When to replace parts for maintenance...

I agree. Or you could just do it once a year, that makes it easy to remember.

Maintenance and engine life go hand in hand. I am anal about my maintenance, I really over do it. But with the money,time and headache put in this thing, I don't want to chance it:)
 
Although you didn't ask about it I replace ALL rubber parts (belts and hoses) every 5 years. My car sees little mileage during that time so I feel ok stretching it, but I know it is all new. I don't want to mess with replacing one hose at a time.
 
My pcv valve,fuel filter,spark plugs,cap and rotor,and spark plug wires were all changed over a year ago. My next oil change is in 2 weeks so i was wondering if i should also replace my plugs and a few other things like the fuel filter.
 
The only way I could see changing anything would hurt the car is if you break something...replacing the parts won't hurt anything, just might not be necessary.

Autolite plugs are like $1.29 at autozone, so for $10, if you want to do the work and it makes you feel better, I say do it. The fuel filter is pretty cheap and easy too, but again, might not be necessary at this point.

I can't see doing the pcv valve/screen since it was only done a year ago and it's a little more involved than plugs.

Basically, I might replace the cheap stuff, but unless the more expensive or harder-to-change stuff fails (O2's, plug wires, cap/rotor), I'd leave it on for another year or two.

I'm no expert - these are just MY opinions :)
 
Sounds good to me,my car is running very strong and has been since i've doem all that stuff over a year ago.I guess i'll change things a sthey break or if i notice a change in performance. I did forget to run fuel injector cleaner my last oil change,so this time i'll buy some when i do the oil change.
 
Goin by age or milege is just a guidline so you can "plan" for expences. The manufacturers figure the age where a certian part begins to fail, and recomend replacment then as prevenative maintence.

Some parts because they may still be good, but not optimal should be replaced more often especailly in a high performance engine.

Some simple inexpensive parts can cause much greater problems if they go wrong. A clogged PCV system can cause oil leaks and can also cause an engine to blow oil up into the intake. A clogged fuel filter causes greater resistance to a fuel pump and can burn out the pump. Bad plugs/cap/rotor/coil/wires can burn out the cats. All of these can reduce the engine's output as well.

If you replace a prevenative maintence part or do a tuneup, and can feel a noticable difference then you were overdue.
 
Don't know what the scheduled intervals are but I know most manuals have them in the first chapter or two.

Belts were mentioned.
I have never replaced a belt due to failure or even significant wear. Unless you count when the air pump seized. In my opinion the belt is a easy visual inspection. If you have custom accessory brackets your belt should be fine for several years. I change the accessory setup (which requires a new belt) more often than I need to replace the belt due to wear.

In my experience over the last 10yrs owning the GT...

I have supsected a coolant stat of failure, but never seen one fail.
I have seen a fuel filter go bad after sitting for 8-9mo. with the fuel lines un-hooked at the motor, but that has been my only fuel filter trouble. I still replace this fairly regularly though.
I have never seen a pcv fail. Every single one I have replaced was still fully functional when removed. Be sure to hold the pcv in the proper orientation when checking it.
I have not seen an egr failure or a iac failure either. They do need to be cleaned though.
I have yet to have a tps sensor go bad. Each time I suspected the tps and replaced it, the problem turned out to be elsewhere.

As a result of all of these experiences I now have many replacement parts that turned out to still be good.:p