Is it even possible? The grey connector that plugs into the back of the headlight switch. I realize it's pre-wired but I would just extend it a bit and use some heatshrink to connect all the wires back. For some reason one of the wires receiving voltage burned all the plastic around it and the connector won't hold the wire in anymore. I have to stick it on through the back whenever I take it off. It also flickers so badly at night (the headlights) unless I have the switch pushed in a certain way. And even then it's really flakey, if I go over a bump my lights will start going off and on. It's a really big pain in the ass.