I am curious where is a good place to by a rotisserie for my Mustang, I am going to completely disassemble the car and will need a way to move it about and manuevre it. Maybe Northern tools? Im not sure where to get a decent one and how much is a fair price to pay.
if you can, weld your own, it's pretty basic and you can make one for fraction of the cost, especially for such a specialty tool, it doesn't have to be pretty just solid and strong
I built one from this link: Rotisserie
Works great. Did cost less than buying one, but for the amount of work, I am not sure I would do it again for the amount saved. The metal was expensive. I saved about $300 if i factor in the castors, shield gas, welding wire, 1/2" nuts and bolts.
And make the verticles a few inches taller than what the plan calls for. It is barely not too short for a 66 Mustang chassis to rotate. I had to put the bottom tie bars low on the outside near where the castors mounted to get the roof to clear when rotating upside down.
That one from Norther Tool is pretty darned nice for the $$$. A lot of great features with bottle jacks included. One improvement I can think of is bigger diameter wheels. Other than that, good bang for the buck.
My $.02,
Gene