• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

Window Problem

  • Thread starter Thread starter Quick Pony
  • Start date Start date Jul 22, 2009

Quick Pony

Member
Nov 28, 2002
129
0
16
Pensacola, Florida
Jul 22, 2009
#1
  • Jul 22, 2009
  • #1
I replaced the window motor (drivers side), on my 1991 LX 5.0 convertible about four months ago. Window worked great! This week when I go to put the window up it stops about 1/2 inch from the top. I can hear the motor when I press the button but won't go to the top. Also the window seems loose when I move it back and forth with my hand.

What could be the problem? Is it hard to fix? Do I need parts to repair?


Thanks

Larry
 
L

Lawbreaker5.0

Member
Feb 20, 2009
543
2
18
Texas
Jul 22, 2009
#2
  • Jul 22, 2009
  • #2
was the motor a remanufactured one?
 

TechSteele

New Member
Mar 8, 2009
60
1
0
North Coast
Jul 22, 2009
#3
  • Jul 22, 2009
  • #3
Sounds like its part Adjustment or Replacement Time.
Which parts are hard to say with that info.
Could be window bushings, retainers, rod locator, grease, motor alignment, drive gear.
It just sounds like something is loose or wore out. With out taking off the door panel and digging in there, hard to guess which it is.
It does sound like the motor is Still working, at least so far. Dont over do pushing it, they are not THE best in the world, and can be burnt out if pushed.
It all sounds mechanical at least, For a change. I have been reading A LOT of electrical door problems lately.
 

Quick Pony

Member
Nov 28, 2002
129
0
16
Pensacola, Florida
Jul 22, 2009
#4
  • Jul 22, 2009
  • #4
I purchased one from Autozone. It cost me $70.00, so I guess it was a remanufactured one.


Larry
 

jrichker

StangNet's favorite TOOL
In Remembrance. Thank you for your contributions
Mar 10, 2000
27,512
2,813
234
Dublin GA
Jul 22, 2009
#5
  • Jul 22, 2009
  • #5
Quick Pony said:
I purchased one from Autozone. It cost me $70.00, so I guess it was a remanufactured one.


Larry
Click to expand...

Check the warranty. If it is still under warranty, swap it out.

If not, then...

Motor removal & replacement
Remove the door mounted speaker & the upholstery panel to gain access to the motor. There are 3 screws (5/16" hex head, I think) that secure the motor in place. Remove them and the motor comes out without any problems. Once you remove all the screws from the motor, and it falls away from the gear teeth on the arm for the glass, the glass will move up and down. You may need a helper to hold the glass once the motor screws are out, since the gear on the motor holds the glass from sliding up or down

Motor interchange
The motor is the same for left side or right side, only the gearboxes are different. If you can't find the complete assembly for the side you want, you can get either side and use the old gearbox on the new motor.

The window motor gearbox has 3 plastic rollers that are a safety clutch to prevent possible injury if the window is rolled up while something or someone is hanging out the window. The plastic rollers will often disintegrate into chunks of plastic and the window will no longer roll up or down. The motor runs, but the window does not move or only move a lttle.

The Help! section of your local auto parts store will have the replacement plastic rollers.
See NAPA Window Regulator Gear Plug

View attachment 250762

Napa p/n BalKamp 6651524

Cost is 9.49$

AutoZone and other auto parts stores see Dorman 74410 / Window Lift Motor Gear Kit
Cost is $7.99

Power Window Wiring Diagrams
Diagrams courtesy of Tmoss & Stang&2birds
87-92 model cars power window wiring:

http://www.veryuseful.com/mustang/tech/engine/images/mustang87-92 PowerWindowWiring.gif

93 model cars power window wiring:
http://www.veryuseful.com/mustang/tech/engine/images/mustang93PowerWindows.gif

See the following website for some help from Tmoss (diagram designer) & Stang&2Birds (website host) for help on 88-95 wiring Mustang FAQ - Engine Information Everyone should bookmark
 
L

Lawbreaker5.0

Member
Feb 20, 2009
543
2
18
Texas
Jul 22, 2009
#6
  • Jul 22, 2009
  • #6
i think autozone has lifetime warranty on most of there stuff. i would try to take it back no matter what. just tell em that its broken, i doubt the will question you, then you can eliminate that problem,

but more than likely the plastic bushings are broken or about to break
 

stang&2Birds

Founding Member
May 4, 2000
2,091
5
58
New England. :-) CT/MA
Jul 23, 2009
#7
  • Jul 23, 2009
  • #7
Just to be sure, put a light coat of grease, Vaseline, or even wd-40 on the tracks. On my '92 Olds, I had rust, then crud build up to such a point where it was nearly impossible to move the window. I was "sure" that I'd have to replace the tracks and the rollers. Nope! It was just rust and grease build up.

If you're near the shore, you may have slat build up inside the tracks along with grease and crud.

It's simple enough to check and do. And, it's better to make sure that crud build up isn't the problem now, instead of buying new tracks, motors, and taking the door apart.

Anyone want to buy a brand new '92 Olds window crank assembly? Hey, at least I didn't buy the driver's side assembly also (which was in even worse shape).

Also, make sure that the rollers aren't worn, and the tracks aren't bent.

Yea, chances are it's the cheap autozone motor. But, it's free to do what I suggested above.

IMHO, regardless, you should upgrade to a '92 Olds crank assembly! I have inside info on where you can get one cheap. Plus, the '92 Olds window crank assembly is 0.000001 ounces lighter. So, your quarter mile times will go down by at least 12 seconds, your gas mileage will be better better than a Pruis, and all the chicks will throw themselves at you because you're so smart!


BTW: Yes, the world is coming to an end. I passed up an opportunity to say that Autozone sells cheap cr*p and they suck. Oh wait, I just said it!
Never mind then, the world isn't ending.
 
You must log in or register to reply here.

Similar threads

B
Front window issues
  • bruno
  • Saturday at 2:16 PM
  • Fox 5.0 Mustang Tech
Replies
5
Views
127
Fox 5.0 Mustang Tech Yesterday at 10:40 AM
AeroCoupe
D
Electrical Weird door wiring issues
  • Dakar09
  • Oct 20, 2026
  • Fox 5.0 Mustang Tech
Replies
4
Views
194
Fox 5.0 Mustang Tech Oct 21, 2026
Dakar09
D
D
Mustang not starting
  • Dawry Ramos
  • Sep 12, 2026
  • 2015 - 2023 Specific Tech
Replies
10
Views
386
2015 - 2023 Specific Tech Oct 3, 2026
Dawry Ramos
D
Electrical problem plug in the drivers kick panel
  • Mindseye007
  • Aug 16, 2026
  • Fox 5.0 Mustang Tech
Replies
3
Views
230
Fox 5.0 Mustang Tech Aug 16, 2026
Mindseye007
Rear window failure
  • Moondog2178
  • Jul 22, 2025
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
6
Views
446
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jul 22, 2025
Moondog2178
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?